Electronics Forum | Thu Sep 22 13:22:59 EDT 2016 | bobpan
Hello, The machine measures the part using the laser on the head after picking it up. It then passes or fails it by comparing it to the part size and tolerance for the pickup in the laser extents. You can see this in central controller under laser ex
Electronics Forum | Wed May 04 21:32:30 EDT 2011 | jimlas53
Thanks for the answer, RLM, I couldn't find anything in the manual that was helpful. If I use a common extent for each component type, I need to identify those components that may be turned due to the feed type (tape, vibe). Is this where I would d
Electronics Forum | Wed Apr 03 16:07:13 EDT 2013 | microaide
OK, so I think I have figured out the machine configuration for tape feeders. BTW, your procedure for retrieving the X/Y/Z coordinates for the pickup locations was wrong. So I looked it up in the Quad manual. The manual was wrong too. Correct procedu
Electronics Forum | Thu Mar 02 04:47:24 EST 2006 | bobpan
If you have an older machine that has cyberoptics you might want to try to put a pickup theta of 90. I believe there was a problem with that type of part. Also use non-leaded alignment and scan the part near the top of it. As for 0402 parts.........
Electronics Forum | Wed Aug 15 16:15:51 EDT 2012 | derekj
Hello all. I'm having a bit of an issue with my IVc that's driving me insane. On occasion when placing a part, the machine will consistently reject the part 3 times before adjusting and then pick and place the part with no issues. I've done everythi
Electronics Forum | Thu Aug 16 12:46:47 EDT 2012 | derekj
Thank you for your reply Bob. 1. It appears the machine is picking the part up, hovering over the board and rejecting it. So it's not blowing the parts out of the pocket. Turning the vv off still results in the same issue. 2. All the tolerances are
Electronics Forum | Wed Apr 03 07:07:44 EDT 2013 | leemeyer
The manuals will not teach you how to use Autoprogram but they will be a reference once you learn it. First you must configure your system. Try this and let me know how it goes. To Configure a machine: -Under Machine Configuration Select Assembler/S
Electronics Forum | Wed Nov 16 14:44:31 EST 2011 | olddog
Bobpan, thank you for your speedy response. As to the items you noted: 1. I did a test of Funct 30 for the first 5 nozzles, 2 times each as follows: noz1 Ht=215 & 219, center=1005 (all nozzles all tests), run out 2.2 & 2.7. Noz2 Ht=228 &228, runout=
Electronics Forum | Thu Nov 17 14:33:02 EST 2011 | olddog
Thanks again Bobpan for all of your help. I hope some of my questions are dumb ones. Regarding "first", the QA error 0, you were right. In checking the setup, for some reason theta was 65227 instead of the 0 that I thought I had set. Regarding "sec
Electronics Forum | Fri Sep 22 15:35:14 EDT 2006 | lheiss
Hello all, Finally ready to run my first 14 up array and the machine picks up the part moves to the placement location, them moves to home and drops the part. The Z axis never moves. I do get a "run error 1" at about the 4th placement (if it was a