Electronics Forum | Mon Mar 11 04:57:31 EDT 2013 | bobpan
You really should edit your programs in central controller where it is much easier to follow the commands shown and to follow the extent data to see whats attached to each part/pickup. The hht can quickly cause issues when the wrong button is presse
Electronics Forum | Fri Apr 05 14:17:11 EDT 2013 | leemeyer
I have no idea why this limitation would be programmed in. Like I said before there a lot of wierd quirks whith this software and you may have just found one. Pre-assigning will not help if the software sees a mismatch between the feeder plate and th
Electronics Forum | Fri Aug 16 03:44:12 EDT 2013 | rollon65
Hi. Sorry I don't have an answer for this but I have the same problem in the "Y" axis on one of my 4Cs after the machine has run for around 4 hours. The machine seems to partially correct for the pick-ups being off as the placements are fairly good
Electronics Forum | Wed Dec 09 17:22:09 EST 2015 | tombstonesmt
I couldn't be more pleased with Panasonic. We've upgraded from MPAV's and MSR's to CM602/DT401 and now their NPM platform. NPM's are extremely fast and accurate. Their auto pickup position teach is great especially if you're running any 0402 2mm pit
Electronics Forum | Tue Feb 24 12:37:43 EST 1998 | Robert
| We are facing some placement problems with | our QUAD 4-C. | Program was running fine last week, Next week | program will be off (placement, pickup,vision files | etc, | Any help, any idea,??? | Thanks Sorry your having trouble, I also have a IVc t
Electronics Forum | Sat Feb 28 01:14:29 EST 1998 | Ray
| | We are facing some placement problems with | | our QUAD 4-C. | | Program was running fine last week, Next week | | program will be off (placement, pickup,vision files | | etc, | | Any help, any idea,??? | | Thanks Glass scales ARE the problem. Th
Electronics Forum | Fri Jul 19 18:21:17 EDT 2013 | microaide
We recently purchased some used Quad 4C machines. One of them does not seem to keep a stable origin reference point. I teach the nozzle and component pickup coordinates, then suddenly everything seems to be off by .030 to .040 inches in the X axis. I
Electronics Forum | Sun Jan 20 17:47:41 EST 2013 | ngineer
Bobpan, It's been a while, and I haven't really had a need for this (simple boards, with larger components), but now I'm back to a board that needs this. I only have options for HOLD, PASS or VISION under transport in the Sequence Programming.
Electronics Forum | Wed Sep 04 09:47:41 EDT 2019 | smrsteve
Hello All, I've just bought a Quad 4c pick & place machine. It's so close to actually building boards, but just doesn't quite get there. I was wondering if there's somebody out there with experience of these machines that might be able to help...?
Electronics Forum | Wed Nov 16 17:30:29 EST 2011 | olddog
Hi again Bobpan, One thing I noticed when I pulled the z-rod to inspect it was that it was "bearly" finger tight. When I replaced it, I snugged it a bit better (not overtightening). After resuming setting up additioanl placements (this board requires
