Electronics Forum | Wed Mar 19 17:18:24 EDT 2014 | aybars
I would suggest to check your servo amps. on both gantries and both axis.Does it rattle both heads or just one? Since you did not specify this in your question,I will say check all 4 servos in the back side of your machine.Hope this will help and goo
Electronics Forum | Thu Jun 06 09:03:48 EDT 2019 | bobpan
If the part is 10mm or less as long as you are scanning it near the top...it should work. The other possible problem is dirt on the quadalign lens. Clean off the lens and watch it when it homes....both heads should home the same way. If the head jum
Electronics Forum | Wed Jul 03 06:52:27 EDT 2019 | bobpan
Seems to be fighting to hold its position. 1. Check for anything worn out...possibly idler bearing/pulley and/or the belt. 2. Maybe it could use servo tuning...this may help but usually servo tuning is not that critical. 3. Clean the scale and the
Electronics Forum | Thu May 02 09:08:13 EDT 2002 | darryl
I have a Quad QSP-2 for 5 years and I have had no problems with it. We run it 16 hours per day 6 days a week. Software is good. Service is excellent Quadcare is expensive. The only drawback that I see is tapefeeder repeatability. Seems that the p
Electronics Forum | Thu May 02 17:00:39 EDT 2002 | gregp
I don't have Quad machines but I would like to say that all Quad machines are not manufactured by Quad. IIC, IVC, QSP-2, APS-1, QSX, AVX are Quad. CP series are Samsung. Meridian series are Mirae. The reliability and ease of use of these models may v
Electronics Forum | Fri Apr 07 16:12:37 EDT 2006 | craig_83
I would like to freeze feeders on a global basis. I am tired of table changeovers everytime I run a different board. A good example is today I ran 1 board which went well. I wanted to run a board behind it that had 99% the same parts. I am not necess
Electronics Forum | Wed Dec 30 12:58:10 EST 2009 | vetteboy86
I'm setting up a matrix tray for the first time on our Quad QSP-2. I believe I have defined the tray and holder. Assigned part numbers. My issue is that instead of teach feeders, I think I need to teach table top. When I do this, I am not finding an
Electronics Forum | Mon Oct 09 06:04:47 EDT 2017 | bobpan
Hello Joyce, Usually I use Very Large cable ties and secure the heads in the opposite corners. I also tie up the z rods or put some plastic tube under the top portion to keep them up. Remove the monitor and bracket off the side of the machine...and i
Electronics Forum | Wed Jun 19 10:40:07 EDT 2019 | bobpan
The only thing left is the read head. Older read heads tend to 'weaken' with age. Sometimes some engineers will shim them up closer to the scale using a 10 mil shim. You could also swap them between gantries...i dont think they are to tough to get to
Electronics Forum | Wed Aug 01 01:35:22 EDT 2001 | DL
Jay, I agree with your assement and Chips on the Quads. I once worked at a shop that had Quads and DynaPerts(at the time) The perts were slower(TIME) and required(EFFORT/PEOPLE) more MAINTENANCE(more effort more people and more requirements!!!). I'v
