Electronics Forum | Tue Mar 18 22:48:24 EDT 2008 | lectronix
We were told to turn on the air supply prior to turning on the power to the machine. We see this error when we forget to turn the air supply on first, you can just aknowledge the error and it will work.
Electronics Forum | Wed May 09 08:48:51 EDT 2012 | leemeyer
Try going into the program definition screen and delete the permanent table top. Then shut down and reboot. The permanent table top will be re created upon reboot.
Electronics Forum | Sat Feb 15 13:06:00 EST 2014 | bobpan
This is a theta axis head 2 error. Manually spin the head and make sure the bearings are loose and spinning. If not, they may need lubricated or serviced. You can also swap theta amps between the heads to see if you have an amplifier problem. Good L
Electronics Forum | Mon Feb 24 14:32:57 EST 2014 | navworx
Thanks Bobpan, It was the theta amp; swapped it to the other side and that side then failed. It would only do it once the unit ran for about 30 minutes. But when it happened, it stayed broken. Swapped out with a refurb from ppm.
Electronics Forum | Thu Apr 09 07:42:36 EDT 2015 | kevinb
Thanks for the info. We tried the reset button but no luck. The UPS is not powering up. We checked the incoming power and it was good. So we took the UPS out and took off the cover to check for blown fuses. We also checked the reset button and it
Electronics Forum | Thu Apr 09 08:59:43 EDT 2015 | bobpan
hahahahaaa......glad I can help..... If you ever need me......go to: www.precision-repairs.com You can e-mail me from there. Bob
Electronics Forum | Wed Jun 27 09:02:51 EDT 2018 | jdengler
A CP IV-3 is able to place 0402's very well. We do it all of the time with a CP IV-2. You need the right nozzles and feeders but no problem. I agree the ProSMT software is a pain but that's not the machine's fault. Jerry
Electronics Forum | Mon Jan 20 05:15:21 EST 2020 | bobpan
Hello, You have a tep initialize issue. Please contact me. If you need my email go to my website and i would be glad to help. www.precision-repairs.com Bob
Electronics Forum | Tue Jun 26 20:44:14 EDT 2018 | deanm
We have four QSV-1s, all with the Windows 7 upgrade. Although they do the job for us and they are still fully supported, I would not recommend them for anything less than 0603. For 0402 and 0201 you need special feeders. We do not use the special fee
Electronics Forum | Mon Mar 10 16:33:37 EDT 2008 | alsnet
Hello Everybody, I'm looking for the AutoProgram Software for Quad IIc machine, Do you know someone who can share me a copy of this?, I can share a copy of the technical manuals of this machine. If you're interested, please let me know. Thanks
