Electronics Forum | Wed Jan 23 13:02:35 EST 2008 | tbkonrad
Thanks for the info. I called Mike Tieman earlier and he recommended I do the exact same things. He said that there should be very little resistance on the theta of the Z-rods, (not the case) so he recommended that the P4 head be replaced. Mike is
Electronics Forum | Wed Jan 23 14:26:52 EST 2008 | operator
I have seen the bad alignment error many times and never had to replace the head for it. It usually has something to do with the laser windows being dirty or cracked. Also it could be your profile settings. Make sure all of these things are perfect b
Electronics Forum | Wed Jan 23 11:28:47 EST 2008 | tbkonrad
Help! Since last Friday i have been having issues with a Quad qsv-1, it all started with a quad align error, i found there to be a small quantity of grease covering the lenses on both quad align sensors. I wiped the grease off and then everything s
Electronics Forum | Sat Feb 15 13:06:00 EST 2014 | bobpan
This is a theta axis head 2 error. Manually spin the head and make sure the bearings are loose and spinning. If not, they may need lubricated or serviced. You can also swap theta amps between the heads to see if you have an amplifier problem. Good L
Electronics Forum | Sun Feb 09 19:16:22 EST 2014 | navworx
Was running production when the head just came to a stop, motor went off, error window said to home. Upon attempting to home, got message: G1T2 homing error; index mark not found. I've tried rebooting the machine, but this error still appears. Any
Electronics Forum | Mon Oct 09 13:36:30 EDT 2006 | ppminc
Phil, The QSA-30 was built by Sam Sung, Sold by Quad. Single Head 2 Nozzles around 11K CPH Quad does not support the machine but I believe you can get parts direct from Sam Sung. I am not sure if they have a registration fee. The QSA used Quad made
.gif)
.jpg)
