Used SMT Equipment | Pick and Place/Feeders
8mm, 12mm, 16mm, 24mm, 32mm, 44mm IQ ( Intelligent ) Surface Mount Tape Feeders and tape feeder reel arms for QUAD Q series and C series pick and place machines. These are the newer 8 pin, deep pocket, feeders and they will work on the newer intellig
Parts & Supplies | Pick and Place/Feeders
Quad Vibratory feeder Quan. 77 Specifications Applicable models : APS-1, QSA-30A, QSA-30V, QSA-60, QSA-60V, QSP-2, QSV-W, QSV-1, QSX-1, IIC, IIIC Feeder width : 76mm (3") Number of pitches : 8 Tube Cassette Width : 70mm (2.75") Electrical Connection
Parts & Supplies | Pick and Place/Feeders
Quad Vibratory feeder Quan. 77 Specifications Applicable models : APS-1, QSA-30A, QSA-30V, QSA-60, QSA-60V, QSP-2, QSV-W, QSV-1, QSX-1, IIC, IIIC Feeder width : 76mm (3") Number of pitches : 8 Tube Cassette Width : 70mm (2.75") Electrical Connection
Electronics Forum | Mon Jan 20 05:15:21 EST 2020 | bobpan
Hello, You have a tep initialize issue. Please contact me. If you need my email go to my website and i would be glad to help. www.precision-repairs.com Bob
Electronics Forum | Mon Jan 20 03:50:37 EST 2020 | falconex_technician
Hi, my company bough second hand pick and place as our second machine. After first transport after start just when initializing, It's showing problem with Z calibration. After second position setup and connect again after month, now showing &
Electronics Forum | Wed Jan 23 14:30:09 EST 2008 | operator
Additionally, I have seen the bad align error from incorrect pickup Z. Quad align can freak out sometimes if it sees something it doesn't like. If all else fails I just reboot and 99% of the time the problem goes away.
Electronics Forum | Wed Jan 23 13:02:35 EST 2008 | tbkonrad
Thanks for the info. I called Mike Tieman earlier and he recommended I do the exact same things. He said that there should be very little resistance on the theta of the Z-rods, (not the case) so he recommended that the P4 head be replaced. Mike is
Electronics Forum | Wed Jan 23 14:26:52 EST 2008 | operator
I have seen the bad alignment error many times and never had to replace the head for it. It usually has something to do with the laser windows being dirty or cracked. Also it could be your profile settings. Make sure all of these things are perfect b
Electronics Forum | Wed Jan 23 12:35:24 EST 2008 | bobpan
Here is a few things to try.... 1. Spin the z-shaft with your fingers and make sure it is smooth and easy to turn. 2. Check your handling in your profile for the part that the software is locking up on.......You cannot go any slower than 40% or this
Electronics Forum | Wed Jan 23 11:28:47 EST 2008 | tbkonrad
Help! Since last Friday i have been having issues with a Quad qsv-1, it all started with a quad align error, i found there to be a small quantity of grease covering the lenses on both quad align sensors. I wiped the grease off and then everything s
