Electronics Forum | Tue Oct 06 05:55:56 EDT 2015 | bobpan
There are known problems trying to create the boot disk if its the older quad software. Contact me through: www.precision-repairs.com I might be able to help you. Bob
Electronics Forum | Fri Feb 03 13:01:52 EST 2006 | MazinK
Hdello BOB, I sent you a message yesterday regarding the machine I have here, Can you please help me, since I knew from people here that you are a good help. Thanks
Electronics Forum | Fri Feb 29 09:13:46 EST 2008 | bobpan
I have seen this on our assemblers look in the machine and check to be sure there is no obstruction IN the down flag sensor located on the bottom of the front transport assembly.
Electronics Forum | Tue Mar 18 22:48:24 EDT 2008 | lectronix
We were told to turn on the air supply prior to turning on the power to the machine. We see this error when we forget to turn the air supply on first, you can just aknowledge the error and it will work.
Electronics Forum | Wed May 09 08:48:51 EDT 2012 | leemeyer
Try going into the program definition screen and delete the permanent table top. Then shut down and reboot. The permanent table top will be re created upon reboot.
Electronics Forum | Sat Feb 15 13:06:00 EST 2014 | bobpan
This is a theta axis head 2 error. Manually spin the head and make sure the bearings are loose and spinning. If not, they may need lubricated or serviced. You can also swap theta amps between the heads to see if you have an amplifier problem. Good L
Electronics Forum | Mon Feb 24 14:32:57 EST 2014 | navworx
Thanks Bobpan, It was the theta amp; swapped it to the other side and that side then failed. It would only do it once the unit ran for about 30 minutes. But when it happened, it stayed broken. Swapped out with a refurb from ppm.
Electronics Forum | Thu Apr 09 07:42:36 EDT 2015 | kevinb
Thanks for the info. We tried the reset button but no luck. The UPS is not powering up. We checked the incoming power and it was good. So we took the UPS out and took off the cover to check for blown fuses. We also checked the reset button and it
Electronics Forum | Thu Apr 09 08:59:43 EDT 2015 | bobpan
hahahahaaa......glad I can help..... If you ever need me......go to: www.precision-repairs.com You can e-mail me from there. Bob
Electronics Forum | Wed Jun 27 09:02:51 EDT 2018 | jdengler
A CP IV-3 is able to place 0402's very well. We do it all of the time with a CP IV-2. You need the right nozzles and feeders but no problem. I agree the ProSMT software is a pain but that's not the machine's fault. Jerry
.jpg)
