Electronics Forum | Wed Apr 26 09:18:19 EDT 2017 | dentata911
Hello Is it possible to make really big placement delay on this maschine? 3-4 seconds? Thank you.
Electronics Forum | Wed Apr 26 11:58:32 EDT 2017 | bobpan
Mod code 7 is a placement delay.....changing it will slow your entire program down. If you just want to slow it down for 1 placement.....you have to insert a mod code change in the sequence steps....this is easily done in central controller. Good L
Electronics Forum | Wed Jun 07 04:44:23 EDT 2017 | dentata911
Thank you for your answer. But maximum value for modcode 7 is 255. 255x3.3 msec is 0.8 sec. And I need 2-3 seconds...
Electronics Forum | Thu Sep 05 12:40:57 EDT 2019 | bobpan
Also check the lae on the pickup that is being dumped. I think its function 16....make sure that the alignment type is 0.
Electronics Forum | Tue Oct 10 12:34:43 EDT 2006 | bobpan
Larry, Do a runstep nozzle then open the door and look and see if the nozzle is all the way on. Push up on it and see if it moves up
Electronics Forum | Wed Sep 04 12:55:51 EDT 2019 | dwl
Sounds like its just rejecting parts. Either the length and width of the component is wrong or the tolerance is set too tight. I don't remember the function codes to edit the tolerance but I left them at 30% (the max) and never had any problems with
Electronics Forum | Wed Sep 04 14:12:26 EDT 2019 | bobpan
It sounds like the vac-verify is not working. There is a command on the hht to turn it off. When turning off your hht will show either 'idle' or enter command' without the V showing anymore. Maybe try the cntrl and vacuum or shift and vacuum. If its
Electronics Forum | Wed Sep 04 12:50:40 EDT 2019 | smrsteve
Thanks for that Steve - I'll try anything at the moment, but that sounds like a reasonable suggestion. I've already replaced a few cables that looked dodgy, and the LEDs on the LED rings, but I've not done a ribbon cable on the head yet. I shall hav
Electronics Forum | Wed Sep 04 13:40:46 EDT 2019 | smrsteve
Hello DWL, Thanks for the response. I've measured the components with a micrometer and set the sizes. Maximum tolerance on my machine is 20%, and that's what I'm using. If I do a manual scan, the measurements are exactly right (and what I've set up
Electronics Forum | Thu Sep 05 08:33:54 EDT 2019 | bobpan
Make sure your placement rotation co-ordinates are correct. If you do a function 3 it will show you. I think they should be in multiples of 6000....ex...6000 = 90 deg. Also check the z axis number. I dont think its cyber or vac related. It is somet