Electronics Forum | Mon Jun 19 09:57:44 EDT 2017 | tnisbet
https://www.youtube.com/watch?v=wbQK3-JwUNQ
Electronics Forum | Mon Jun 19 11:53:22 EDT 2017 | westshoredesign
Out of curiosity, are these compatible with all C series models?
Electronics Forum | Mon Jun 19 09:53:27 EDT 2017 | tnisbet
Hi, Yes you can add a paste dispenser to the Quad 4C. The system will dispense DOTS and DOT patterns, no lines. We sell kits to add the dispenser. It takes about 4hours to install the kit. We also sell Camalot dispensers, benchtop & floor models. w
Electronics Forum | Tue Jun 27 08:53:43 EDT 2017 | westshoredesign
PPM, like mentioned above. You'll find they have most, if not all parts you'll ever need. http://ppmparts.com/spares/pickplace/quad/
Electronics Forum | Mon Jun 19 21:17:41 EDT 2017 | arachid
https://www.youtube.com/watch?v=wbQK3-JwUNQ > https://www.youtube.com/watch?v=wbQK3-JwUNQ Hi, where can i get price and where i can buy the kit.6 Thanks
Electronics Forum | Fri Jun 23 13:02:45 EDT 2017 | arachid
Hi, where can i get price and where i can buy the kit?Thanks
Electronics Forum | Mon Jun 19 08:49:40 EDT 2017 | westshoredesign
Just buy a separate machine to apply paste. You'll be able to run faster, (by doing more at the same time) and you can probably find an air-over-syringe system for less than $2000USD. At the end of the day, that's probably less than you'll spend in t
Electronics Forum | Sun Feb 10 15:14:25 EST 2013 | marcelorotofrance
After an in depth examination, I found that the problem was not a defective connector as I thought in the first place. Actually is a broken through-hole on the Quad Align sensor. I requested a spare part to PPM. Mr. Bobpan, thank you again.
Electronics Forum | Mon Feb 04 06:48:50 EST 2013 | bobpan
Do a function 30 on the hht and you should get a nozzle height of around 200. If its not and its around 1 you have something on the quad align lens and you will have the exact problem you are having. Hope this helps... Good luck
Electronics Forum | Mon Feb 04 11:01:44 EST 2013 | bobpan
The way its supposed to work...is....when you do a function 30 the z axis should step down until the nozzle tip is seen in the quad align or laser align. The readout should have a nozzle height but if its the earlier firmware for the machine it might