Electronics Forum | Mon Jan 21 08:26:45 EST 2013 | ngineer
Bobpan, Thanks for the reply. I have been using Tep Vision, I'll see whether I was using GOTO 1 or 0, it may have been 0. I am running from central controller, and am doing a download database from the database utilities when making changes on
Electronics Forum | Fri Feb 24 13:21:42 EST 2012 | bobpan
The correct sequence steps should be: 1. tep hold 2-? pick/place/nozzles tep vpass goto 1 This is out of the programming manual.
Electronics Forum | Mon Jan 21 08:36:23 EST 2013 | bobpan
The global or image fiducials is set under teach fiducials screen. You will get the option to turn on the one you want. You should choose one or the other depending on what you are building. You are correct for what tep hold,pass and tep vision does.
Electronics Forum | Thu Feb 02 15:46:31 EST 2006 | MazinK
Hello Bobpan, Thanks for the reply. Please I need help, we have a quad machine here (QSV1 PLUS) and had problem Not INitilizing the machine, and keep give a message says, (( BUFFER FULL IN LINE 4), and FACTNET.CPP LINE 4. Quad saying could ne one of
Electronics Forum | Mon Jan 20 05:15:21 EST 2020 | bobpan
Hello, You have a tep initialize issue. Please contact me. If you need my email go to my website and i would be glad to help. www.precision-repairs.com Bob
Electronics Forum | Mon Jan 21 06:04:12 EST 2013 | bobpan
Some things to try.....keep in mind it has been over 10 years since i programmed one of those machines. 1. Tep Vision is what you should be using. I think it was called tep vpass in older software. 2. Maybe try goto 0 instead of goto 1. 3. Make sure
Electronics Forum | Mon Jan 21 09:54:22 EST 2013 | ngineer
Bobpan and all future people with this problem, GOTO 0 Fixed the problem. It also counts boards now. I never knew why it didn't count the boards run. Haven't looked in the manuals, but I would bet that it shows this plainly. This makes sense,
Electronics Forum | Mon Nov 24 16:29:10 EST 2014 | kevinb
I have a Quad QSV-1 machine. It has been off for over a year with no power to it at all. I found out that I lost the BIOS on the machine. I have two QSV-1 with the serial numbers one apart from the other so I copied the bios from one to the other
Electronics Forum | Tue Nov 25 08:36:32 EST 2014 | bobpan
Tep stands for the transport card. The board is located in the front bottom left of the machine and should be by itself and have green and red leds lit on the top of it. I would try to reseat the card and then try to reboot the machine. If the proble
Electronics Forum | Sat Mar 09 02:25:35 EST 2013 | ngineer
I'm setting up a rather complicated job on our quad IVc. I was almost done (after days), and after i did the sequence, i saved it, downloaded it, and started checking the picks and places, well, i needed to change one, and went back to the sequence,
