Electronics Forum | Fri Apr 03 13:53:41 EST 1998 | Ron Beasley
| | | We are in the process of deciding whether to change a PCB product from a single board to a 3 up panel array. Could you please advise on the most effective removal design, either scoring or snap off, taking into account that material utilisati
Electronics Forum | Sun Apr 05 14:57:10 EDT 1998 | Earl Moon
| | | | | We are in the process of deciding whether to change a PCB product from a single board to a 3 up panel array. Could you please advise on the most effective removal design, either scoring or snap off, taking into account that material utili
Electronics Forum | Thu Dec 18 14:44:59 EST 1997 | Scott Cook
No problem..... > No; the last time I used the process was 1983. > Yes, and in your neck of the world, I'd bet you're looking at Flutec products.....(I used PP11 juice way back in 1979). > I would dispute this. I did EXTENSIVE testing for thermal eff
Electronics Forum | Mon Aug 25 12:18:10 EDT 2008 | evtimov
I am looking for an inexpensive way to bake just > a few components. would a toaster oven be okay on > the low setting (i would get a thermometer!) do i > need to get something to place the components on? > maybe a silicon cooking mat (not sure a
Electronics Forum | Tue Mar 04 01:00:19 EST 2008 | gdzuber
Recently I have been hearing and see this excess flux residue problem at several companies, US, Mexico, and Japan. It seems to have increased recently. In fact, it seems so common that it seems normal, but if everything is correct, a re-flow oven sho
Electronics Forum | Wed Mar 17 19:57:08 EST 2004 | Dreamsniper
Do you wanna save the BGA or what? Do you have an electric stove, baking tray and a BBQ clip? Does your wife love cooking? if u have one of each, then u don't need a reflow oven which is too expensive and you don't need to buy heating guns or drill p
Electronics Forum | Wed Oct 19 00:28:59 EDT 2005 | KEN
Lets talk some facts here. I have 6 BTU VIP's. 29,000 combined run hours. Not one part replaced in 6 years of operation. NOT ONE across 6 sepearate machines! I have had up to 6 Hellers at one time. Do you know why they have a life time warranty
Electronics Forum | Fri Dec 27 17:13:53 EST 2019 | rhormigox
Thank you for the answers. The paste is as spec No-Clean https://www.chipquik.com/datasheets/TS391SNL50.pdf I'am writing them too. For the excessive cooking not sure, the oven sensor (that I think is about right) looks I am close to the profile, bu
Electronics Forum | Wed Aug 04 22:35:32 EDT 1999 | ScottM
| What oven temperature should be used to reflow solder (Sn63Pb37) on a PC board (0.075" to 0.100" thickness) in 5 to 10 minutes? | D... is correct -- it's all dependent on your paste and your oven. Call your paste supplier (each one has a technica
Electronics Forum | Mon Dec 16 10:05:29 EST 2002 | Grant Petty
Hi, Thanks for the info. We are reflowing the boards, but just barely. Sometimes we get the QFP in the middle of the copper area not reflowing, and it's pain. The joints are dry, and I am not sure if it's caused by lack of heat, or the flux going ba
