Electronics Forum | Tue Oct 12 12:38:29 EDT 2021 | cunningham
We have had alot of issue with REHM our BTU on the other hand very little issues
Electronics Forum | Fri Sep 16 19:46:55 EDT 2011 | jlawson
I have seen this on Heller1707 machines also for LED devices. The same job was run on anthoer brand oven (Rehm) and no issue. I think Heller Blower velocity can be a little on higher side as is a low inertia heating system and they have to make up f
Electronics Forum | Fri Sep 24 07:31:13 EDT 2021 | mun4o
Hi all, our company planning to buy a new /third/ smd line.I have choose P&P ,and solder paste printer , but I hesitate about reflow oven.Now we have two smd lines.The first oven is a old ersa hotfow5 - very robust machine. The second reflow oven is
Electronics Forum | Mon Mar 20 15:41:00 EDT 2023 | oclsc
Hallo SMTnet. We have just bought a VXS Air 3.2/634 Rehm reflow oven. We are wondering why the conveyor chain in the oven is still running two days after the "Auto OFF" precedure/program has been activated. In this case the oven set to "Auto Off" Fr
Electronics Forum | Tue Mar 21 11:57:27 EDT 2023 | stephendo
Or after a preset amount of time. Maybe the oven has a setting somewhere that is not set propely.
Electronics Forum | Mon Mar 20 22:08:24 EDT 2023 | tey422
For reflow oven to "auto off" it has to go through the cool down; it should be off went the cool off temperature is reached. Perhaps you need to 1st check if something prevent the oven reach the cool off temp (both hardware & software).
Electronics Forum | Tue Apr 18 07:19:19 EDT 2023 | bukas
hi, does anyone know what type is Carlo Gavazzi sensor on REHM SMS2 reflow oven? The only marking I see on one I have is "Tripleshield tm"
Electronics Forum | Wed Nov 17 05:20:38 EST 2010 | jlawson
Also please contact Rehm Thermal, they make best Vapor Phase systems in terms of cost of onwership - less galden usage than Asscon or IBL, have more controllable ramp rate control vs the other vendors also...use patented galden injection on demand an
Electronics Forum | Thu Mar 31 10:22:57 EDT 2011 | swag
We are going to buy a new reflow oven. I'm currently comparing Rehm VXS3150 and Heller 1809 Mark III. Both should meet our needs as far as zones. Does anyone have experience to share for either? Good service from these companies?
Electronics Forum | Sat Jul 16 13:53:52 EDT 2022 | yannick_herzog
Hello all, we use a reflow oven from Rehm in our SMT production. At the moment we solder under nitrogen atmosphere (approx. 500ppm). Now we want to reduce the nitrogen consumption (costs etc.). What consequences can occur here? Especially on the s
