Electronics Forum | Thu Mar 30 13:15:17 EST 2006 | gregp
Maybe the issue is how the feeders are being unloaded. The operators should leave enough covertape to reload the reel onto a feeder without component waste. If the issue is some parts are exposed in the feeder then you will most likely loose those p
Electronics Forum | Mon Nov 13 09:37:14 EST 2006 | pforister
Hello, Is there an alternative program that I could use to program my Quad 2c and 4c machines? My 98 machine just crashed and the IT department does not want to re-load 98. I don't believe Autoprogram works on Windows NT, 2000 machines. I do know
Electronics Forum | Sat Aug 04 03:39:39 EDT 2007 | ahdo
Good day, can i seek an advice regarding wave soldering. Will it be advisable to reload the board two times to improve its barrel fill volume? If yes, what is the maximum number of times we can repeat wave soldering on the same board. If no, what
Electronics Forum | Wed Dec 12 19:37:52 EST 2007 | marcelll
On a old VIP 98 oven. Since we reload the software, we have a problem with the board tracking system. Board is flagging the entrance pcell, we can see it on the graphic screen, but alarming all the time when at exit end. Alarm is "board droped in ove
Electronics Forum | Mon Mar 03 11:37:34 EST 2008 | lysik
OK I'm a tech and I would not start with replacing both a computer and a camera. spend as much time with tech support as possible via telephone that is what they are there for. If they can't help keep posting this message. The good old stand by is to
Electronics Forum | Fri Sep 26 08:11:15 EDT 2008 | dwelch123
Try swapping cards in Y1 enclosure. You can swap zero and one or two and three but make sure you change the shunt position and the dip switch settings and see if your problem switches cards. The lithium battery likes to fail on those cards. Reload th
Electronics Forum | Mon Jun 08 16:49:15 EDT 2009 | joshuas
has anyone experienced a x-axis vision error on MPM ultraprint HiE 3000? The only solution for me so far, is to save the program as another name and reload the original. This corrects the problem although only a temporary fix. is there a permanent
Electronics Forum | Mon Oct 11 17:14:30 EDT 2010 | markhoch
I've had this problem before. Typically happens when the Lithium Battery dies and the machine loses the program. Usually you can pull the displays out and ship them to Simplematic. They can reload the program for you. Roughly $2500 bucks I think. Cal
Electronics Forum | Wed Dec 22 17:58:57 EST 2010 | padawanlinuxero
Hi probably you have a problem with one of the boards in the machine, like the M-Board, have you tryout reloading all the boards? and then re start all the hardware?, had a similar problem and we bought a new M-Board and fix the problem. Do you hav
Electronics Forum | Tue Jun 28 14:55:11 EDT 2011 | remullis
Typically TH equipment has 2240 Unused steps if no pattern is loaded when running a pattern it takes up whatever amount of steps deducting from the 2240. With no patterns loaded in my axial machine I only have 246 steps. Would this be a time to relo
