Electronics Forum | Wed Feb 25 09:22:53 EST 1998 | Earl Moon
PCB Fabrication Supplier Evaluation And Qualification Made Easier Supplier evaluation and qualification often is left to uninformed industry references or vague suggestions made by sales unprofessionals. This discussion is met to enhance a customer'
Electronics Forum | Wed Feb 25 09:21:05 EST 1998 | Earl Moon
PCB Fabrication Supplier Evaluation And Qualification Made Easier Supplier evaluation and qualification often is left to uninformed industry references or vague suggestions made by sales unprofessionals. This discussion is met to enhance a customer'
Electronics Forum | Fri Feb 14 12:22:57 EST 2020 | etmpalletguy
OK, you can't glue, Pallet Guys pallets are out the door, dual line reflow prevents from any lower temp solder paste.... Do you have a 3D printer? Are there parts underneath the connector in question? Measure the PCB thickness, pint out a custom hold
Electronics Forum | Sun Aug 08 11:15:32 EDT 1999 | Earl Moon
| | Mike, | | | | Got your message and those of others concerning PCB fab supplier evaluation and qualification check lists, etc. I have a severe problem here in WI as I can hardly access the internet, and when I do it is cut off abruptly for no goo
Electronics Forum | Sat Aug 03 07:29:20 EDT 2002 | davef
IPC-PE-740 "Troubleshooting for Printed Board Manufacture and Assembly" has words to the effect of � 1.5---BAKING Laminate materials are baked several times during the manufacture of a printed wiring board. There are four major reasons for
Electronics Forum | Sun May 24 06:02:33 EDT 1998 | Earl Moon
| Hello, | I am looking for suggestions for cleaning pcb's after the routing (fabrication) process. Keep in mind that these pcb do not have components intalled on them yet. | We have considered pre-drilling the routing plunge points, but cost and ca