Electronics Forum | Wed Nov 25 12:33:16 EST 1998 | Scott Snider
| A buddy of mine has problems after depaneling double sided pre-scored PCB's. Resistors near the edge, after put into the slice and dice machine contain micro cracks. He's checked for them before and after depaneling. We figure it is the sectioni
Electronics Forum | Sun Dec 03 15:35:44 EST 2000 | Michael Nguyen
Wow. And I thought I was the only one having problem with ceramic capacitors.I too am having problem with cracking ceramic capacitors 1206 package.We changed vendors and still having the same problem. I had to reverify my entire process and I had to
Electronics Forum | Sat Dec 14 02:29:52 EST 2013 | padawanlinuxero
Hello I hope this helps For a component with axial leaded - vertical The clearance of the component body or weld bead above the land is 1.00mm (0.039in) Component body must be perpendicular to the board The overall height does not exceed maxim
Electronics Forum | Mon Aug 13 18:16:31 EDT 2001 | fmonette
Be very careful how you perform the removal process if you want to re-use BGA/CSP devices. As you are aware, the majority of these components are classified as moisture-sensitive by the manufacturer. This means that if they absorb too much moisture
Electronics Forum | Thu Jul 20 13:57:04 EDT 2000 | Boca
I am not answering for Techguy2000, but I am chiming in here, I have the same problem. Our resistor packs are ceramic body with no leads, they have a metalized area reminicent of the old castelation leads of year gone by. The lead pitch is 50 mil
Electronics Forum | Mon Feb 25 07:59:47 EST 2002 | Jim Mills
Customer has requested a custom CBGA pakaged resistor network.I've seen a lot of info about TCE mismatch but aslo have heard that using 0.025-0.030 balls offers some stress releif which allows for the TCE mismatch to become less of a problem. Would
Electronics Forum | Wed Sep 28 01:32:15 EDT 2005 | Mika
Try vision type 12 for capacitors, this will give you much better acceptance in the vision inspection, since those are slightly rounded. Resistors works normally fine with vision type 10. If you have a component that is very hard to get pass the visi
Electronics Forum | Thu Sep 24 17:00:03 EDT 2009 | dogsbody
would any body be able to supply me with infomation on how to adjust a quadalign unit,as a unit on my line will not pick up 0603 resistors,but will pick up thicker 0603 caps. My manuals offer no help.I have run the aligner calibration with the cone t
Electronics Forum | Mon Jul 29 08:34:40 EDT 2013 | gallionc
I don't see an issue. As was mentioned before, it is what the customer wants. You could approach this from one of two ways. You could simply install the parts, clinch the leads on the opposite side for added mechanical strength and solder the parts
Electronics Forum | Wed Aug 07 18:18:08 EDT 2019 | slthomas
We mostly do it by package and/or functional description. Certainly you should be able to ignore any passives (chip caps, resistors, diodes), and plastic bodied ICs and SOTs which will cut down the research dramatically. Beyond that, we mostly jus