371 right angle led misagling results

Full Site - : right angle led misagling (Page 5 of 6)

Pattern Design for Panasonic Right Angle LED's

Electronics Forum | Fri Sep 15 10:00:15 EDT 2006 | Joe C.

Hello Everyone, Does anyone have any experience with an SMT right angle LED from Panasonic, part number LNJ123W8PRZ. In our experience the pattern design from the vendor was not very effective (the part swam around on the pads & flipped backwards dur

SMT before through-hole

Electronics Forum | Tue Aug 14 16:26:21 EDT 2007 | slthomas

So it's a C-n-C clearance issue? Could you go with the other cutnclinch unit...which ever you have, get the other one (one's right angled, one's offset at 45�)? Yeah, I know, they're not cheap. Other than that, hand place some of the SMT in chip bon

OSRAM Power TopLEDs with dome

Electronics Forum | Tue May 03 15:19:12 EDT 2005 | cuculi54986@yahoo.com

Thanks for the suggestions. We have been going around the dome to pick from the base. The placement machines are Panasonic chipshooters - MV2VB and MV2C. I have several problems with the MV2C. The K-type feeder plates were moved by my predeces

HELP ON SANYO TCM-V822 HIGH SPEED MOUNTER

Electronics Forum | Fri Dec 02 17:28:35 EST 2005 | ratsalad

We have a TCM-V822 over in the warehouse that had a severe head crash. If you suspect you have a bad servopack, contact Unidec. They can test it for you. If it tests bad they can rebuild it for you and you won't have to wait for months to have o

GSM2 spindles Not seen for head

Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval

Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the

AOI Algorythms

Electronics Forum | Thu Jun 22 10:23:14 EDT 2006 | cuculi54986@yahoo.com

I'm no AOI expert by any means, however I spent a few minutes one time about 4 years ago working on an old CR Technology (or is it CR Technologies?) machine so I've been chosen by my company to be the "technical guy" for our AOI evaluation. We are l

Re: DFM / DFT information

Electronics Forum | Thu Jul 13 22:20:38 EDT 2000 | Dave F

=10 mils larger than lead 3 silk screen legend text weight >=10 mils 4 pads >=15 mils larger than finished hole sizes 5 place through hole components on 50 mil grid 6 no silk screen legend text over vias (if vias not solder masked) or holes 7 so