Electronics Forum | Wed Jun 25 18:17:48 EDT 2003 | Brian W.
Water soluble pastes generally work best with a ramp-to-spike reflow profile. Check your paste manufacturer's recommended profile. There are many factors that impact your profile; board thickness, component density, buried thermal masses, board si
Electronics Forum | Tue Jun 24 09:42:52 EDT 2003 | stepheno
The temprature for the first zone should be less as the PCB entering the oven from the ambient shop floor temprature would suffer a thermal shock from a higher temp. Experience must be gained from profiling a board with thermocouples, otherwise you
Electronics Forum | Wed Oct 02 18:18:58 EDT 2002 | davef
The steadfast rule of thumb is: In order to get reliable reflow, you need to be at or higher than [liquidus + 20�C] for about 5 to 10 seconds, rather than those old "60 seconds above 183�C" guideline. This provides for setting your peak based on the
Electronics Forum | Thu Sep 26 11:44:23 EDT 2002 | abelardo
Hello everyone out there in the SMT world. I have a dilema I'm currently running a board that has 3 csp's with a .75 mm. ball pitch and .3mm ball size. And 2 qfp's-160. The stencil is 4 mils thick and I'm using a 63/37 solder paste. My reflow prof
Electronics Forum | Tue Aug 23 03:29:37 EDT 2022 | samhe
I received a buck-boost DCDC board with an optical sensor from NextPCB, so I mounted the components and measured the efficiency. Table of contents Board received from NextPCB Solder paste printing Mounting of parts Reflow operation check Attaching