Industry News | 2013-04-12 07:16:19.0
When the Paragon Electronics Group decided to establish a new business in the form of a specialist independent component distributor in late 2011, they knew they were entering a somewhat crowded marketplace. However based on its mix of global sourcing capability and a sophisticated in-house component test laboratory, the company’s mission to support OEMs and CEMs by locating problem parts and offer the UK’s leading component verification and counterfeit screening services, has got off to a flying start far exceeding the company’s expectationsand forecasts.
Industry News | 2016-03-24 21:59:25.0
Circuit Technology, KIC, KYZEN, Nordson DAGE, Aqueous Technologies and AIM Solder announce that they are working together to present the “Reliability Workshop: Cleaning – Materials – X-ray” in Raleigh, NC on Tuesday, April 12 and Asheville, NC on Thursday, April 14. Both workshops will take place from 8 a.m.-4:30 p.m.
Industry News | 2021-12-27 20:17:56.0
The lubricating oil used in a refrigeration compressors can lubricate the friction surface, reduce the friction work, friction heat and avoid wear of the compressor motor. Besides, filling the sealing part with oil can ensure its performance and prevent the leakage of refrigerant. Here are four reasons why the oil of refrigeration compressor deteriorate.
Industry News | 2021-08-19 05:26:13.0
First, you need to do the following things before starting the servo motor.
Industry News | 2021-05-24 04:37:04.0
HVAC stands for heating, ventilation, and air conditioning. This system provides heating and cooling to residential and commercial buildings. These systems use fresh air from the outdoors to provide high indoor air quality. The V in the HVAC or ventilation is the process or replacing or exchanging air within a space.
Electronics Forum | Thu May 04 20:33:12 EDT 2023 | stephendo
Are you talking imperial or metric? A metric 0201 is three sizes smaller than an imperial 0201. The paper describes metric 0201 as about the size of a grain of sand. That would be pretty fine sand.
Electronics Forum | Fri Sep 08 13:14:14 EDT 2000 | Charlie
Can any one tell me where to get sand bags used to hold parts down at wave?
Electronics Forum | Thu Jan 28 13:26:20 EST 2010 | plerma
how about a light sanding ?
Electronics Forum | Tue Feb 02 11:59:20 EST 2010 | stepheniii
How about sanding then plating fresh copper?
Electronics Forum | Tue May 11 18:59:36 EDT 2021 | rgduval
It's annoying, but, the last time I was faced with a similar issue, we ended up sanding the edge on the PCB after depanelization. I stronly recommend charging for this service. It could be sped up by using a Dremel fixed in a vice, but, I would cau
winsouce.jpg)
.gif)
