Electronics Forum | Fri May 04 14:47:15 EDT 2007 | jasont
Chris, I have x2 units available in my Brockville, Canada warehouse now. They are off MPM UP 2000 HiE's and the model #'s are as follows; MCU012A-SOO AP25-917A Please e-mail directly at jason@tekmart.com Looking forward to your reply, Jason
Electronics Forum | Sat Jan 21 11:39:11 EST 2023 | atpico
Thank you Michal, The MPM error messages are ambiguous to say the least and one axis not zeroing was a possible cause. But I put here what I learned again and again with this machine: when something doesn't work start by checking the fuses, all of
Electronics Forum | Mon Aug 26 11:13:49 EDT 2002 | Marco Prince
There is a new tooling invention called the Instant Fixture System. It is a mechanical "cartridge" style dense pin-array system. There is a kit for MPM-UP 2000, and AP Series, and also for DEK-265 platforms. This instant fixture system offers very
Electronics Forum | Wed Dec 28 18:09:47 EST 2022 | atpico
Second question concerning MPM UP2000HiE: Are there two options of conveyor lengths for this printer? Looking for conveyor belts spare parts I found two options: One 137" and one 106" that gives about 134 and 174cm total conveyor lengths. Does any
Electronics Forum | Thu Jan 19 18:11:45 EST 2023 | atpico
My UP2000 HiE Printer on Power-ON during initial Reset will show this error and reset will abort with no way to continue. E00938 10 - HARDWARE LIMIT WARNING In Input/Output Screen all Sensors are in normal situation and will react normally when t
Electronics Forum | Thu Aug 31 00:08:54 EDT 2006 | jasmin
Hi Sr Tech, You can contact by email address : sales@baoding.com.sg for the quotation that i send to you earlier. Thanks & Regards Jasmine
Electronics Forum | Thu Mar 16 20:21:19 EDT 2023 | compit
Brantco - can I also ask? zaopatrzenie@compit.pl I have a UP2000 HiE manual but a paper one - I can check something if someone needs it.
Electronics Forum | Wed Aug 30 10:42:42 EDT 2006 | chrisgriffin
I would recommend the UP2000 HiE. This would more than handle what you have describe. If you have a lot of warped boards, the side clamp retro might be for you. I haven't had much production experience with the grid lock, but I know of several pe
Electronics Forum | Tue Aug 29 14:21:24 EDT 2006 | billyd
Dude: I have used the Grid-lok system before, in DEK 265 and DEK Infinity printers (clamps) and they worked quite well. But, we did have the side clamps. I'm not sure how that translates to an MPM. They were the best we could find as far as the
Electronics Forum | Wed Dec 28 11:05:27 EST 2022 | atpico
We have 7.2E (MS-DOS variant) software version on our printer and there are some annoying bugs and less than optimal NPI process (when the new board need to be put on and put off the rails several times during NPI teaching). Is there a known newer/be
