Electronics Forum | Wed Sep 02 16:47:03 EDT 2015 | curiousman
Hi all, My company recently purchased a preowned EBSO SPA 400-F, and I am trying to get it up and running. Still need to get a few other parts like a nozzle and nitrogen generator, but in the meantime I was looking to clean out the residues and oxid
Electronics Forum | Sun Sep 01 22:02:58 EDT 2019 | sarason
Have you got a circuit diagram for your driver board? If not measure your driver into a resistive load and look for differences in current flow voltage drops under load dried out caps. Dead current measuring circuits etc. If you see an IC, look it up
Electronics Forum | Wed Jan 30 13:45:59 EST 2019 | slthomas
I'm wrestling with the infamous adjustable torque drivers on the production floor. Despite a procedure that clearly forbids it, we still have the occasional know-it-all that will just crank the knob until the desired setting is visible in the windo
Electronics Forum | Fri Jul 23 14:07:52 EDT 1999 | Carl J. Odle
We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that after a p
Electronics Forum | Wed May 29 08:28:41 EDT 2002 | zanolli
Hello Mr. Peterson, I don't know where you're writing from, but if you're more than 25 miles from Rhode Island, I'll humbly and graciously accept the "expert" title. In general, I have to say that the backpanel removal tools are worth the money. As
Electronics Forum | Tue Jul 02 15:50:28 EDT 2002 | blnorman
FIrst, be a doubting Thomas and never trust supplier propaganda sheets, do your own testing. How often do you knead the paste? We have a standing requirement that if the paste printer is idle for 30 minutes, we have a minimum of 4 kneads before pri
Electronics Forum | Wed Oct 30 10:55:53 EST 2002 | ahobby
I hope you'll take an answer from the sunny UK. I don't usually read these forums but contribute to similar over here, hence the late response. We have an Invicta Sabre 757 machine in our Demo room, running with Zestron SD 300. We give the PumpPrint
Electronics Forum | Thu Mar 04 18:18:02 EST 2004 | Ken
There is a japanese company that makes a ultrasonic hand-held stencil cleaner. I demo'd it for a day and it was fantastic! It even cleaned epoxy stencils. Can't recall the price...but it should be much much less than the smart sonic and other "mac
Electronics Forum | Tue Apr 17 14:57:10 EDT 2007 | ratsalad
Hi there CK, I didn't follow the link yet, but I thought I'd comment on your post here. I've attended two engineering schools in the USA, and one of them was a pretty darn good school. At both, I would have to say about 80%+ of the graduate studen
Electronics Forum | Mon Apr 19 15:45:21 EDT 2010 | dwonch
Thanks to all for your input. We did have a third party do an analysis on boards from the first shop. They were shipped directly from the board shop to eliminate the possibility that we could contaminate them. The third party (Forsite) did find Sili
