Electronics Forum | Tue Mar 06 15:59:33 EST 2007 | pima
hello I would like to ask you for advise. I have problem with one of my SMT line and skewed parts at the end of line after reflow. My line is composed: DEK, 3d visual inspection of paste printing, IP3, 8 zones reflow oven. I m builidng there produc
Electronics Forum | Tue May 22 17:21:43 EDT 2001 | davef
BGA require placement accuracy of only 0.3mm (�12 thou), compared with a required placement accuracy of 0.08mm (�3 thou) for fine pitch devices. Even with this level of misalignment, plastic BGA self-center / self-correct during reflow due to symmetr
Electronics Forum | Fri May 29 13:42:34 EDT 1998 | Steve Gregory
Hi Jason! I can probably find something documented for you, but the easiest way to convince your QA people is just to show them. If you have a board around that has some 1206 locations all in a row, print the board with paste and then plac
Electronics Forum | Fri May 29 16:12:11 EDT 1998 | Jason Gregory
| Hi Jason! | I can probably find something documented for you, but the easiest way to convince your QA people is just to show them. | If you have a board around that has some 1206 locations all in a row, print the board with paste and the
Electronics Forum | Sun Apr 12 08:49:12 EDT 2009 | mki
Hello, I bought used QUAD IVc MKII with transport in "as-is" condition, powered it up (without air and PCB on machine) and all axes (X, Y, Z AND T(heta)shows signs of life. Machine is performing HOME positioning self test. I am not familiar with QUA
Electronics Forum | Thu Apr 04 05:33:19 EST 2002 | ianchan
Hi, hope this helps : 1) BCC (bump chip carrier) production for us, was with a 5mils Stencil. The outer perimeter smallish pads are not much of a problems. For the central large pad, we split the paste print (corresponds to the Stencil apperture op
Electronics Forum | Mon Dec 20 13:39:08 EST 1999 | Wolfgang Busko
Hi Clarissa, seems to be a real start up situation you are in. For the printing there is IMO no need to buy any sophisticated automatic-vision-alignment-self-cleaning-inline-and-more-machine. Features you need: - adjustable in X-,Y-,Z-axis (individu
Electronics Forum | Wed Nov 13 16:48:19 EST 2013 | spoiltforchoice
I would expect any half decent machine to place 0603 parts slap bang on target to the typical defined accuracy for such parts on most machines of perhaps ~60 microns or better. Self correction during reflow is IMHO much less pronounced with lead-free
Electronics Forum | Sat Mar 28 06:45:31 EDT 2020 | aswa1111
Hey everyone, I hope all of you doing well this time of the year. We have an old Juki / Zevatech 740 pick and place machine and we got a problem with the vision alignment, every placement is off by 2mils. How can you run an offset calibration on t
Electronics Forum | Fri Jul 30 17:13:30 EDT 1999 | Dave F
| | | Looking for solder paste specification limits which have reliability data to support them. Currently, we are looking to define the min/max volume necessary to ensure a good joint on CBGA, PBGA, and Micro-BGA's. Any information will be greatly
