Electronics Forum | Fri Dec 19 17:11:24 EST 2014 | guts1872
My QSP2 motors keep shutting off with an error message on the screen that says Z1 motion fail. Z safe motion motion failed due to previous error. When homing the heads I observe the servo amp indicator LEDs. They are all green while the gantries are
Electronics Forum | Fri Jan 15 14:32:12 EST 2021 | marcelorotofrance
Hey there We have a second hand (or third or fourth...) Contact 3Z-100 non functioning, received as is. I am in the process to asses its condition and try to get a diagnosis. After DOS boot, 3Z.EXE executes and in the screen it reads: "Initi
Electronics Forum | Sat Jan 29 12:01:32 EST 2011 | jts142
hi i am having problems with a cp 643 when i run in auto it errors unloading a board with the x axis servo interlock error but if i hit sequence end stop so that it stops after every board it runs and unloads perfectly. Any hints or suggestions we ha
Electronics Forum | Fri Sep 18 03:02:07 EDT 2015 | linux
Hello everyone. Need urgent help with our cp6, when front door is open servo amp alarm comes up, this error will clear using the reset button. Has anyone any idea how I would go about fixing this issue.
Electronics Forum | Tue Feb 01 13:21:34 EST 2011 | cyber_wolf
Try switching to a different board and see if the error goes away. If it does, it has something to do with one of the loader sensors not being made.
Electronics Forum | Wed Jun 25 18:19:49 EDT 2014 | guts1872
During machine run, sometimes when we stop to change parts the servos wont start back up. There is a message on the screen that says "Amplifier is resetting power". When that message clears and push the servo on button nothing happens. There is an er
Electronics Forum | Tue Jul 08 15:34:21 EDT 2014 | guts1872
Unfortunately it seems we have a worse problem than a Z rod spring. The machine was running fine this morning but ran out of a part, and when I shut the door and pressed Servo On nothing happens again. I shut down and let sit for a while. Now I get a
Electronics Forum | Wed Mar 20 14:05:29 EDT 2019 | alexcouto
Hello again, I put the motors 1 and 6 back in their correct positions, but head 1 now gives me a new error. will it be necessary to configure the head 1 motor in any way? I was still checking to see if the belt and the engine would be in position, bu
Electronics Forum | Thu Mar 21 02:52:59 EDT 2019 | bukas
looks like home sensor problem, whats the error message? does head 6 now work properly?
Electronics Forum | Fri Mar 22 03:19:43 EDT 2019 | bukas
well, in video shown it looks like #1 motor drives head #1 upwards but does not detect home sensor being triggered. and then you get timeout error, head not being able to reach the position ( machine not registering it has reached position). since yo