Electronics Forum | Thu Jan 04 21:38:27 EST 2018 | dekhead
Error is occurring during move to fiducial 1 position (from board stop position)? Or during move to board stop position (from park position)? What is error displaying onscreen? Did you also just replace belt(s)?
Electronics Forum | Wed Mar 11 12:23:08 EDT 2009 | rodrigo
I changed the satus B bit to disable the MTU (still on though). It doesn't wait for the MTU anymore but I get a Emergency and Door NG errors. The relay tripped. Is there a way to completely disable the MTU (leave it off) and power up the IP? This sho
Electronics Forum | Sat Sep 05 02:34:19 EDT 2009 | martinphill
check R-axis mechanical backlash... After checking R Axis Backlash, Coupling. If still the Problem continues. We have the same issues & when we asked Jagadeesh Rajagopalan , he suggested following action item Check the servo Error display. If it i
Electronics Forum | Mon Mar 04 13:48:53 EST 2013 | orlando216
Greetings to all, I have the following problem with an IP-3 from Fuji, At display is says: Cannot Move: X1 Axis Feeding aborted Servo Alarm X2 AXIS Servo Ove
Electronics Forum | Mon Mar 09 13:07:52 EDT 2009 | rodrigo
Hi all, Our IP-2 stop working during production with a Servo NG error. Turning it on and off just goes back to the same thing or "Turn servo power on" error message. I was checking the power for the servo amps and I found a 35VAC line that is missin
Electronics Forum | Mon Aug 31 09:16:54 EDT 2020 | aurash
After reading the machine logs it seems that the problem is on the X-axis but the safety mechanism is disabling all the Servos and the Axis system (all axes) are in error state (that's why the error messages are showing on different axes) The JUKI m
Electronics Forum | Thu Mar 25 07:59:57 EDT 2010 | fredc
Hello Rodrigo, My expierence is with metal cutting machine tools not Fuji placement machines. That said there are a several of areas to look at. #1.Interference on your C axis travel, look for scrape marks or something dragging on the drum. #2. Tigh
Electronics Forum | Wed Oct 25 11:25:12 EDT 2017 | paddyronan
Hi all, I have a recent issue with an IP3 machine. The machine cycles through normal power up routine. Then the video monitor and VME card shit themselves down and after a couple of minutes the CPU board powers down. However this is intermittent. Wh
Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Tue Oct 11 19:17:29 EDT 2005 | Dave
Hi Stephen! The nozzle change happens at a much slower speed to what it runs at during pick and place. They are a great machine...when everything works on them ;-) I tried sending through the proper data again and rebooted the machine. A interest