Electronics Forum | Sun Jan 30 20:13:32 EST 2022 | chuckphd53
I have a SMT-460 machine that works pretty good for the most part. When placing parts I have an issue with the SOT-23 rotation 90deg. Using both Juki 503 / 504 nozzle it will pick and place all of the 0805 and 1206 resistors/caps just fine. I have 9
Electronics Forum | Wed Dec 02 11:15:35 EST 2009 | tpappano
wycliffe (and I suppose anyone with a vision system): You may save yourself some considerable headache with your CSM84VZ if you check one simple thing before you get too far: Make sure the long skinny macro lens on the head camera is screwed in snu
Electronics Forum | Tue Oct 20 10:31:50 EDT 2009 | lloyd
Seth, From the Siemens technical information document: Raceway monitoring detects incorrect positioning of the Z axis with respect to the raceway during motion of the star. This is done by monitoring the current drawn by the Z axis while the star i
Electronics Forum | Sat Sep 16 12:49:36 EDT 2006 | magszoo
I'm hoping that someone may be able to shed some light on this error we've been getting on our DEK 265LT printer. Several months ago we began getting a "Rising table position error" after the operator would open the hood to load paste or after changi
Electronics Forum | Tue Mar 10 14:11:42 EDT 2009 | rodrigo
Ok I checked and here are the results... Z1 11CS3x Green LED on Q1 11cs4x Green LED on Z2 12cs3x Green LED off (This is the relay I mentioned in my original post). Q2 12cs4x Green LED on M1CR4x Green LED off The servopack SA-6 is the one with the
Electronics Forum | Wed Jul 01 13:41:25 EDT 2009 | jlawson
Are you sure it is the Z axis, and not the > rotation, I had one machine which often did > something similar, it would buzz loudly, > especially if you touched or applied rotation > pressure to the gear belt which rotates the > head. It never ca
Electronics Forum | Fri Jul 29 17:41:35 EDT 2016 | ddina
I appreciate your response. I kind of read about it, and made sure nothing sensor-wise is activated by mistake on the process of zeroing. Right now the machine is in this set up, and the rear rail is all the way to the back stop. So the sensor on the
Electronics Forum | Mon Feb 04 17:47:20 EST 2019 | arbpkevin
When I power up the machine and it finishes booting into VIOS, I normally hit the ready button to power up the drives so I can perform the origin search. Instead of "latching on" the contactors pull in, and then quickly release. If you hold down th
Electronics Forum | Fri Dec 02 17:28:35 EST 2005 | ratsalad
We have a TCM-V822 over in the warehouse that had a severe head crash. If you suspect you have a bad servopack, contact Unidec. They can test it for you. If it tests bad they can rebuild it for you and you won't have to wait for months to have o
Electronics Forum | Thu Jul 15 21:10:53 EDT 1999 | Scott McKee
| I was wondering if someone could help me with a little problem I am Having with a MyData TP-11 UFP running TPSys 1.4.2. Early this week the machine crashed and I had to reload the software. I re-insatalled Venix then the CP4 driver then TPsys and S