Electronics Forum | Thu Dec 14 21:56:25 EST 2017 | jmelson
I checked the brushes, there is lots of length left on them, and the springs and pigtails are in good shape, too. I have been checking various cables, and reseating connectors, but making a resistance measurement from the brush holders back to the s
Electronics Forum | Wed Feb 23 15:07:58 EST 2005 | bobpan
Hello C.B. I am a former trainer/fse for that machine and still have a q1000 bible for fixing problems. I think the machine may need servo tuned to which there is a procedure that i would have to find. First thing to do though, is to drop the machine
Electronics Forum | Thu Feb 13 09:52:03 EST 2014 | rgduval
Start by getting into the maintenance menu, and manually installing the Servo program for all MOTs. If they install fine, you can check the Z-motor while you're in the maintenance menus. Make sure that the z-locks are unlocked before checking the
Electronics Forum | Mon Nov 29 13:39:48 EST 2021 | oxygensmd
Is it a running machine or a first startup? For me, it seems to be some configuration error. For example problem with some card (iCos, MC, servo controller). At first check table and WPC connectors are fitted properly than check the status LEDs on y
Electronics Forum | Thu Apr 28 03:58:52 EDT 2022 | erici
We are having problems with our Siemens Siplace S27 machine. The machine is giving the error - Y-axis Faulty initialization of Motor. We replaced the Y motor card and swapped also the servo control cards on the two gantries. Still will not initiali
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Mon Jun 12 17:54:17 EDT 2017 | simons
The machine does not move to the home position. Once we hit the "Home" button all three heads will move up to the "Home" position but then 5 to 10 seconds later the following error pops up "Error 1531 - Z Axis motor alarm" before any "xy" movement i
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Sat Aug 08 09:45:11 EDT 2015 | edwaterfall01
It would be helpful to know what happened before the error occurred. Do you have another machine so that you can swap some boards? The Force CPU, (machine controller) located in the VME, is responsible for controlling all machine-related activities.
Electronics Forum | Mon Dec 06 21:07:36 EST 2021 | victorzubashev
Hi, you have flickering that affects all AC power in the machine (PC is also connected to the AC line (after step down transformer)), correct? Do you intermittently/randomly lose power in all machines units(MC/PS/Servo)? If I understood you correctly
