Electronics Forum | Mon Jul 06 22:17:13 EDT 2009 | emanuel
Thanks Jeff, I isolated the problem to the DC servo part. The GD3 signal in the safety circuit chain is the one that generates this L004 Feedback Error - which by the way next to it I get also (Wn) where n is changing form 1 to 3 every time I push r
Electronics Forum | Tue Apr 21 12:48:13 EDT 2009 | bk
ok you verified that the motor was bad. So now i would go back and verify that your voltages are still good on the back of the computer box and on the booster board. If they all check out fine. I would take the mot x board from your working machine a
Electronics Forum | Sat Sep 05 02:34:19 EDT 2009 | martinphill
check R-axis mechanical backlash... After checking R Axis Backlash, Coupling. If still the Problem continues. We have the same issues & when we asked Jagadeesh Rajagopalan , he suggested following action item Check the servo Error display. If it i
Electronics Forum | Fri Jul 07 17:17:43 EDT 2023 | ttheis
We swapped the Y1 and Y2 pc800 controllers with no change. We swapped out the UIMC III-I cards from another machine with no change. VRM amps all look OK, no errors. The machine moves the head both in the x and y directions during the zeroing attemp
Electronics Forum | Mon Mar 04 13:48:53 EST 2013 | orlando216
Greetings to all, I have the following problem with an IP-3 from Fuji, At display is says: Cannot Move: X1 Axis Feeding aborted Servo Alarm X2 AXIS Servo Ove
Electronics Forum | Fri May 06 15:15:19 EDT 2005 | lyrtech
Hi, I have an INTERMITENT error on my FUJI IP-2 that cause to me many headaches. The error is " SERVO NOT GOOD". In the books, it means that it is relative to servo amplifier. But I can't assume that is the problem because sometimes the machine wor
Electronics Forum | Thu Jan 04 11:07:59 EST 2018 | ilavu
Ray, Did you solve this problem? I am having same error on same model machine. My problem is, when camera axis moves to look at the first fiducial, camera hits to the cleaner and error comes up with rising table error, camera axis not home. Even log
Electronics Forum | Mon Oct 10 15:24:15 EDT 2005 | zl3vlf
Hello to all! Our Fuji FIP-3 placement machine has come up with a servo alarm (X2-axis) whenever we try to run the machine. The manuals don't go into a lot of detail as to the cause of this problem, but there is plenty of information on what the X2
Electronics Forum | Thu Sep 16 21:22:39 EDT 2004 | Darby
Cesar, I am not familiar with these machines but I have found that servo controller problems do not usually cause mis-placement. They tend to just stop the machine with *axis system erors. As I understand it, after you have done a return to origin,
Electronics Forum | Sun Mar 31 07:43:32 EDT 2013 | lkavan
Thank you very much, you are an angel, DOS software works with these drivers! But some servos still shaking and I cannot tune it by decreasing the gain or autotuning :-( Problem is with driver, when I change it servo works well. All drivers have the
