Electronics Forum | Wed Jun 08 14:04:50 EDT 2005 | cyber_wolf
If you are facing the back of the machine take left most panel off. There are usually two fans built into this panel.(unplug the fan connector and set cover aside) The servo-driver cards will all be in a row. They should be labeled accordingly.
Electronics Forum | Fri Sep 16 08:36:45 EDT 2005 | ajay
check some relay might be bad on MTU. we faced similar problem in IP3.
Electronics Forum | Wed Dec 20 07:08:51 EST 2006 | cyber_wolf
We have had this happen. The Z-ball screws do go bad in IP3's. We replaced the ball screw and the problem went away. As mentioned improper belt tension will cause the servo to make loud noises. But if you say the movement is rough, then the ball scr
Electronics Forum | Tue Nov 18 13:08:28 EST 2008 | andras
GeorgeS: I'm pleased to help you. I was in the same situation some years ago... tpappano: no problem, download it. But it should be noted that it is for CSMs with DC servo.
Electronics Forum | Mon Mar 09 15:40:32 EDT 2009 | smellew
Rodrigo, Is your machine IP2 or IP2E? if you still have the problem contact me direct, and i will take you through the Schematics. Llew Llew@SurfaceMountEngineering.com
Electronics Forum | Thu May 04 15:32:21 EDT 2017 | dilogic
On the HP Servo panel there are LED's that indicate state of limit switches - so you can see if the problem is in the switch or somewhere else. Did you check it?
Electronics Forum | Fri Jan 05 12:02:28 EST 2018 | ilavu
Camera works fine from home to ref. position to fiducial1 and 2. Problem shows up from home to board stop. AC voltage between AC1 and AC2 is 41.7 and during move it drops to 41.5.
Electronics Forum | Fri Sep 03 03:54:13 EDT 2021 | sophyluo1985
I'm Quinn, maybe we at GOLDLAND can help you, please send us the details of the problem you encountered. Website:WWW.GOLDLANDSMT.COM Tel : +86-18033446355（Whatsapp/WeChat） Skype: QUINN LUO Email: sales07@feedersupplier.com
Electronics Forum | Thu Jun 29 10:19:34 EDT 2023 | gfe
Hello, I have a problem with the mirae mx200l, the Y1 servo has error 38, does anyone know how to fix it?
Electronics Forum | Thu Sep 15 13:55:31 EDT 2022 | jojoled
Hi all, I need help with problem Iam stuck with JUKI KE760L. -SERVO ALARM 1 and ALARM4 https://photos.app.goo.gl/CCDcNtbbEhJLBo47A Sometimes I do get error ON ALL 4 SERVO drivers (1-2seconds after starting the calibration routine (even before the Z
