Electronics Forum | Wed Aug 24 11:32:08 EDT 2016 | mnorthey
Did you get your problem solved? I don't remember exactly what I did for that problem but it may have involved changing a servo or driver card. I do have a copy of the calibration/repair manual if you want it. I also have some Nozzles NC-1410 (1.0
Electronics Forum | Wed Oct 12 22:22:31 EDT 2005 | zl3vlf
Hi all! Well installing the servo card has fixed the status LED issue....however there is a new problem :( When a production program is executed at the IP3 (pressing AUTO or START) the machine says 'communicating with the VP' (which is normal). Wh
Electronics Forum | Fri Jan 10 15:33:57 EST 2014 | hans88
Hello Rob, Thanks for your fast reply. I will check the parts you mentioned. You were right about the mot card we swaped it with a new one but that made no difference. Today we tried to find were the problem could be we: - removed the j1, j2 and
Electronics Forum | Thu Jul 06 19:41:31 EDT 2000 | Hermie
We recently installed a new Servo-Amp which controls the X-Y table on our CP6 machine. Eversince, we are experiencing a Cycle alarm X-reach on the machine. We tried to greased the table a little bit more but the only thing that seems to work is to sl
Electronics Forum | Mon May 03 18:03:43 EDT 2004 | ms
Have any of you had experience with Hti-7pc or Hti-7nt printers? Our one's computer died, and with the replacement we get a "Servo drive failed - during startup" error message during initialisation. I understand Hti are no longer in business. Mike
Electronics Forum | Mon Oct 10 22:56:13 EDT 2005 | Alan.
Dave, it could be that you have some dirt or grease on the linear scale for the X-axis. Try getting into the rubber shield with a soft brush or perhaps a spray. Threebond Super Cleaner 6602 is very good for this purpose as it cleans and dries w
Electronics Forum | Sat Aug 19 08:01:39 EDT 2006 | johnw
I am experiencing the same problem just now on one of my FCP643 machine only when I change program and the machine moves to load position to clamp the board, as soon as I get to the bottom of this I will let you know.I suspect its the Z-AXIS loader c
Electronics Forum | Sat Aug 19 08:14:25 EDT 2006 | johnw
I am experiencing the same problem just now on one of my FCP643 machine only when I change program and the machine moves to load position to clamp the board, as soon as I get to the bottom of this I will let you know.I suspect its the Z-AXIS loader c
Electronics Forum | Tue Nov 02 07:19:26 EDT 2010 | raghu
Dear Team, Can we apply staking after conformal caoting? If we do this can we expect any future problems. Please clarify our Doubt. Your reply in this regard is highly appreciated. Thanks & Regards, Raghuveer S. Medha Servo Drives Pvt Ltd.
Electronics Forum | Thu Apr 28 03:58:52 EDT 2022 | erici
We are having problems with our Siemens Siplace S27 machine. The machine is giving the error - Y-axis Faulty initialization of Motor. We replaced the Y motor card and swapped also the servo control cards on the two gantries. Still will not initiali
