Electronics Forum | Thu Feb 04 09:18:18 EST 2010 | mika
Problem! Then replace the motor! Why not replace be belt anyhow? How long was it since the last time you replaced any belt? Another thing you could also do; In the LP (Low Power) chassis lower front left, find the correct motor servo card and "Null
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Sat Jun 11 03:27:30 EDT 2016 | muzzy
Hello. We have a problem with our Juki 740 machine. It does not start at all, both monitors are blank. The only error we can see is "FAIL" LED on CPU board and red "LD2" LED on "AC SERVO BOARD". Does anyone know what the "LD2" LED means? Or, even be
Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu
John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN
Electronics Forum | Wed Jun 19 10:11:59 EDT 2019 | jamesn
Hi to everyone I hope someone can help me with a problem I have on a Quad QSP-2. when calibrating ( Or trying to use ) Feeder Bases 2 and 4 on gantry 2 Im getting small amounts of accumulative drift in the X axis. I have changed the servo amplifier
Electronics Forum | Sat Aug 08 23:38:06 EDT 2020 | jmelson
Well, the machine is here, it has some probems that I need to diagnose, and now I ***REALLY*** need the manuals (both maintenance and operations). Two problems. One is that it will only come "ready" (servos powered on) ONE TIME per day! I'm totall
Electronics Forum | Fri Jan 06 16:14:10 EST 2006 | trynders
Have had a lot of issues with our machine and was just curious if anyone else out there was having any problems with theirs. This is actully our second 3Z. Our first one had so many problems Contact took it back and replaced it with a newer one. Abou
Electronics Forum | Fri Nov 18 02:42:46 EST 2005 | vinitverma
Greg, I recently faced this problem at a customer though the machine was Topaz X but the problem was same. So I suggest you first check if the GOOD LED is ON on the Servo card down in the MCX box. Also check the same GOOD LED on the System board in
Electronics Forum | Fri Jan 10 00:56:53 EST 2003 | fastek
You really must be on a tight budget since most people will pay YOU to take these models off their hands. What is your budget for capital equipment? Zero? That said, I think you would be better served to step up a generation and look at MPA-3's inste