Electronics Forum | Sat Jun 11 03:27:30 EDT 2016 | muzzy
Hello. We have a problem with our Juki 740 machine. It does not start at all, both monitors are blank. The only error we can see is "FAIL" LED on CPU board and red "LD2" LED on "AC SERVO BOARD". Does anyone know what the "LD2" LED means? Or, even be
Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu
John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN
Electronics Forum | Wed Jun 19 10:11:59 EDT 2019 | jamesn
Hi to everyone I hope someone can help me with a problem I have on a Quad QSP-2. when calibrating ( Or trying to use ) Feeder Bases 2 and 4 on gantry 2 Im getting small amounts of accumulative drift in the X axis. I have changed the servo amplifier
Electronics Forum | Sat Aug 08 23:38:06 EDT 2020 | jmelson
Well, the machine is here, it has some probems that I need to diagnose, and now I ***REALLY*** need the manuals (both maintenance and operations). Two problems. One is that it will only come "ready" (servos powered on) ONE TIME per day! I'm totall
Electronics Forum | Fri Jan 06 16:14:10 EST 2006 | trynders
Have had a lot of issues with our machine and was just curious if anyone else out there was having any problems with theirs. This is actully our second 3Z. Our first one had so many problems Contact took it back and replaced it with a newer one. Abou
Electronics Forum | Fri Nov 18 02:42:46 EST 2005 | vinitverma
Greg, I recently faced this problem at a customer though the machine was Topaz X but the problem was same. So I suggest you first check if the GOOD LED is ON on the Servo card down in the MCX box. Also check the same GOOD LED on the System board in
Electronics Forum | Fri Jan 10 00:56:53 EST 2003 | fastek
You really must be on a tight budget since most people will pay YOU to take these models off their hands. What is your budget for capital equipment? Zero? That said, I think you would be better served to step up a generation and look at MPA-3's inste
Electronics Forum | Sat Nov 28 22:12:33 EST 2020 | tueftler
Hi there :) I have an used IPulse M1 PnP machine since one week. In 2016 the machine had get a full service with update the OS from WinNT to the newest WinXP-Program. I had tested the machine on sellers production hall - All was running great. Now,
Electronics Forum | Thu Nov 24 04:21:02 EST 2005 | Twistie Ng
NEED EXPERTISE HELP / SOLUTION for Sanyo TCM-V822 High Speed Mounter. Errors Message Code : REEL TIMING 01 18 & REEL SERVO 01 01 ============================================================ This unit has yet to run since our purchase a month ago.
Electronics Forum | Mon Jun 12 09:07:10 EDT 2006 | JimC
Flux: Getting enough- is the spray fluxer getting good through-hole penetration. Try cranking it up. Soltec spray fluxers are not really as good as Ultrasonic Systems or Sonotek ultrasonics or the new ServoJET, but should do the job. Also, try anothe
