Electronics Forum | Thu Jan 20 06:01:23 EST 2005 | mhe
Hi guys, we are facing a problem - d axis servo overflow in our fuji cp-4. Can anyone please suggest some remedy? thanks deepak
Electronics Forum | Fri Dec 19 17:11:24 EST 2014 | guts1872
My QSP2 motors keep shutting off with an error message on the screen that says Z1 motion fail. Z safe motion motion failed due to previous error. When homing the heads I observe the servo amp indicator LEDs. They are all green while the gantries are
Electronics Forum | Tue Jan 24 16:35:16 EST 2017 | siltron
Hi everyone, We bought a used Juki KE a few months ago. Installed it at the beginning of this year, but have some problems with the Z and ROT servos. As soon as the machine is powered on, the ALM04 red led turns on on some of the Z and ROT drivers.
Electronics Forum | Thu Jul 10 19:26:21 EDT 2014 | guts1872
It looks like we did have an interlock problem. Maintenance re possitioned them and it seems to have cleared up our problem. For some reason when we close the door, it still wants to reset the Amp power, but if we wait for the all clear in the GUI be
Electronics Forum | Fri Feb 04 01:31:44 EST 2011 | fujiphil
Possible cause is the Middle Loading Sensor. Check the ML flag. Also, this problem occurs when the z-axis base slips. Need to level the base and re-calibrate z-axis origin.
Electronics Forum | Sat Jan 29 12:01:32 EST 2011 | jts142
hi i am having problems with a cp 643 when i run in auto it errors unloading a board with the x axis servo interlock error but if i hit sequence end stop so that it stops after every board it runs and unloads perfectly. Any hints or suggestions we ha
Electronics Forum | Wed Jul 09 05:06:52 EDT 2014 | bobpan
Are you sure you don't have a door interlock problem? Some of the covers of mirae machines have a physical switch and a magnetic switch that both have to be made for the interlock to be closed. It could be if you have a magnetic switch that the magne
Electronics Forum | Tue Jul 08 15:34:21 EDT 2014 | guts1872
Unfortunately it seems we have a worse problem than a Z rod spring. The machine was running fine this morning but ran out of a part, and when I shut the door and pressed Servo On nothing happens again. I shut down and let sit for a while. Now I get a
Electronics Forum | Fri May 01 16:04:17 EDT 2009 | jimmyboz
I found your ealier thread, when you swapped amps for trouble-shooting, as a rule of thumb, always swap them back, otherwise, you may introduce a new unexperienced problem. The original problem, (Z2 according to the thread) will not influence H1 unl
Electronics Forum | Fri Mar 08 04:08:39 EST 2019 | alexcouto
The video of the problem can be seen in the following link: https://meocloud.pt/link/5fd24217-3fe8-4e53-8ca3-7be8f04ca7fa/V_20190307_182529.mp4/
winsouce.jpg)
.gif)
