Electronics Forum | Wed Jul 04 03:59:10 EDT 2018 | oxygensmd
I had similar problem before. I cleaned the PCs (both machine and station) and replaced the cooling paste on the CPU cooler. After time the Control was able to shut off - before the issue solved, we used the safety knob to cut the Control.
Electronics Forum | Fri Feb 14 14:35:44 EST 2020 | emeto
From what I remember, shut off machine, unplug cable/hose, unscrew 4 screws and the head is out.
Electronics Forum | Wed May 20 16:07:22 EDT 2020 | stephendo
You want a big enough storage tank to smooth pressure. Figure out what size pipes you need and go a size bigger. Make a loop of the pipes with shut offs. That way you can shut down any section and still have air to the rest of the air line. Run the p
Electronics Forum | Fri Apr 26 15:00:44 EDT 2013 | leemeyer
This is what the manual says about this message : Power Failure Detected A main power failure occurred and the machine is being powered by the UPS. All heaters are shut off immediately ad the conveyor clears all boards If main power is not restored w
Electronics Forum | Thu May 13 12:24:26 EDT 2004 | cyber_wolf
We have an older line scan camera on our MY series machine.(The one that uses the X wagon trigger/encoder to turn on the line scan)When I go into the service program and turn the line scan camera to "camera action on" the LED's will only stay lit for
Electronics Forum | Thu Jan 27 20:17:25 EST 2022 | stephendo
What exactly counts as "always on"? Our ROHS wave solder machine is always on during the week but the pot shuts off at the end of the shift and turns on early in the morning so that the solder is melted before we get to work. It is only using a small
Electronics Forum | Wed Aug 08 15:43:48 EDT 2001 | Claude Couture
Low tech suggestion: turn monitors off manually after use. High tech suggestion: install a "presence" sensor, like those on some photocopier, that turns on the monitor when someone is near it, then a time delay for shutting it off.
Electronics Forum | Tue Jan 31 02:59:18 EST 2006 | jgarver1
You also should check to make sure you have blow off at the placing station set properly. I have seen machines with the flow control valve shut completely off not release parts properly. The parts end up in the scrap bin and the machine thinks they
Electronics Forum | Tue May 07 13:51:51 EDT 2013 | shankar2013
acceleration is set to lowest. Ribbon cables were replaced, theta motor replaced. I also see a message pop up just after F-MOT1-26/156:MOVFI: MOTOR TIMEOUT / F-AXIS-182:C-AXIS NOT properly out when expected / 25v reads 3V. Now all these messages
Electronics Forum | Wed Apr 30 11:41:55 EDT 2008 | gemengr
It back running now, after shut it off over night, it power back up,look like the heat sensor under of 4 resistors is start getting bad.But i'll by pass it, if it happen again. Thank you for your in put.