Electronics Forum | Wed May 13 00:52:36 EDT 2020 | gabriel1blue
I need help. I have a old panasert MV2C pick and place machine that was working great until we had to shut down due to the Covid-19 pandemic, and now everything is off. We had the system data saved but even after we restored everything from Japanese
Electronics Forum | Wed Jul 26 16:08:29 EDT 2006 | ev
My focus has moved to the X motor itself. The one common factor in this paricular problem has been the time of year. The day was a particularly hot day with high humidity. Even though there is a "Xfan" connection on the PIAB board I do not believe th
Electronics Forum | Wed May 09 11:05:26 EDT 2001 | davef
IPC-7525 "Stencil Design Guidelines" �9 END OF LIFE, states "Stencils should be inspected periodically for damage that would conribute to decreased printing performance. Refer to Section 7 for inspection guidelines." Or words to that effect. Now b
Electronics Forum | Fri Jun 22 12:25:42 EDT 2001 | dason_c
DaveP, once you shut down the oven, the moisture will start and move into the oven unless you can completely seal the oven after you turn it off. Therefore, keep the components into the oven, don't work. However, if the oven is continously on until
Electronics Forum | Wed Jan 21 10:27:27 EST 2009 | gidster
Ok. As you know the machines changed a bit after > 95 due to CE regulations. > > There are no drawing > on board/box level in Panasert > machines. > > However normaly i`ts the 100 volts > thats "shorting out" the machine and shuts it > down. C
Electronics Forum | Tue May 07 16:19:47 EDT 2013 | dyoungquist
The "25v reads 3V" part of the error message may be your clue. Since the machine runs for a while and then shuts down, something may be failing after it warms up. "F-AXIS-182:C-AXIS NOT properly out when expected" refers to the centering jaws not o
Electronics Forum | Thu Aug 04 09:40:12 EDT 2022 | jojoled
Hi, did anybody face such error(attached)? After calibrate all axis I get this error. "E202074 : Z axis of left head : SERVO alarm. Turn off the power to the machine and perform inspection" - see attachement. Machine was fully working day
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Mon Apr 29 00:29:11 EDT 2013 | aemery
If you have a UPS on your machine there should be auxiliary contacts in the main breaker switch SW 1. These contacts tell the UPS if the main rotatary switch in turned to on or off. If the rotary switch was set to off the UPS knows not to turn on i
.gif)
.gif)
