Electronics Forum | Mon Oct 02 13:04:54 EDT 2023 | proceng1
I did a post a while back about this with Selective. I don't recall all the details now, but you can search it.
Electronics Forum | Sat Feb 16 07:21:17 EST 2019 | SMTA-Joe
I am experiencing a "tarnishing" issue on PWB traces that may be causing problems with component reflow. The PWB traces are made to the following spec: SOLDER MASK OVER BARE COPPPER WITH SILVER IMMERSION PLATING PER IPC4553, PLATING TO BE 8-12 MIC
Electronics Forum | Sat Aug 15 06:29:40 EDT 2009 | abeasia
Help, experiencing discolor of a white solder resist paint after reflow of 250 degree, it turned yellow. Have tried many paints, no luck. Anyone knows one that wouldn't change color and holds the white nicely? Thanks for your support in advance.
Electronics Forum | Wed May 30 10:09:39 EDT 2012 | brettrenishaw
Recently we have noticed a purple-blue colour film on the surface of the molten solder. It can be cleared when de-drossing the pot. The pot will normally go a yellow/gold colour before it turns purple-blue. Is this most likely an oxide of the tin or
Electronics Forum | Thu Aug 28 04:07:46 EDT 2008 | kelson
Hi robinj As you have mentioned, if the color is yellow usually it is caused by moisture left on the boards from poor drying after immersion silver. However, our boards were received from the supplier and the changes happened in our side. So, what di
Electronics Forum | Mon Oct 02 14:46:06 EDT 2023 | davef
Lab tests can confirm the composition of your material. I'm going with tin oxide. Tin oxide changes color depending on the thickness of the deposit. Your deposit is fairly thin. It will change to a brown color as the thickness increases. Your EDX
Electronics Forum | Thu Apr 07 10:39:36 EDT 2005 | geb
I have a BTU International VIP98 reflow oven, running WINCON Version 2.00C on Windows 98. The light tower only lights green when the oven reaches temperature, and the other colours never light up. Do you know how to set the other colour lights to tu
Electronics Forum | Tue Jan 16 18:13:25 EST 2007 | greg york
Try to process the composite pallet through the wave without any flux and view volume of smoke and if any residue is deposited in the wave when it exits. My guess is that the pallets are releasing some binders that are high boiling and this in turn c
Electronics Forum | Tue Apr 17 13:07:17 EDT 2012 | rodrigo
Well... after much headache I found a bad relay contact in M1CR1E. The good news is somehow the axis are no longer jerking. The bad news is that it still does not work. When I turn it on now it shows this: emergency stop (in red) waiting for reset
Electronics Forum | Thu Aug 21 22:47:39 EDT 2003 | adlsmt
Well after reading all kinds of stuff about this I still question if it is my current problem BUT, how common is this??? I dont want to be afraid of the boogie man but it seems like a lot of folks are having problems with black pad. I have used imers
