Improve test coverage and reduce cost. The XJTAG XJLink2-CFM adds the power of XJTAG’s boundary scan solution to the Teradyne TestStation, giving test access to hard-to-probe parts of a board. Both JTAG and non JTAG devices, such as Flash, RAM, Eth
EKT AOI machine application: inspection after stencil printing, pre/post reflow oven, pre/post wave soldering?FPC etc. Stencil printing: Solder unavailability, insufficient or excessive solder, solder misalignment, bridging, stain, scratch etc. Compo
Industry News | 2013-10-21 12:53:27.0
ADLINK Technology will present amongst other products the following highlights at productronica: PXIe-9529, Newest High-Density Dynamic Signal Acquisition Module for Sound and Vibration Testing.
TI New and Origina OPA317IDCKT in Stock IC C-70-5, 2021+ package OPA317IDCKT Low-skew, rail-to-rail I/O op amp Today's Hot Deals： MK64FN1M0VLQ12 LQFP144 FAIRCHILD 20+ SPBTLE-1STR MODULE STM 19+ UJA1169ATK/F/3 HVSON20 NXP/ 22+ TAS5755MDFDR HT
Industry News | 2014-06-26 20:12:53.0
Isola Group announced the introduction of Tachyon-100G laminates and prepregs, which enable line cards required to transmit 100 Gigabit Ethernet (100GbE) at data rates in excess of 25 Gb/s per channel. Tachyon-100G has identical electrical properties as its predecessor Tachyon; however, the Z-axis coefficient of thermal expansion (CTE) on Tachyon-100G is more than 30% lower than Tachyon, making it more suitable for fabricating high-layer count, 0.8 mm pitch line cards with heavy 2 oz. copper inner layers.
Parts & Supplies | Other Equipment
We support Samsung Smt Machine spare parts for CP30,CP33,CP45,CP45NEO,CP60,CP55,CP10,CP11, SM321,SM320,SM411,SM421,SM431,SM471 etc machines nozzle, Feeder, CPU Board, IO Board, Laser, Cable, Feeder cart, Motor, Driver ect thanks CP30
Used SMT Equipment | General Purpose Test & Measurement
Stanford Research SR785 The Stanford Research SR785 Two-Channel Dynamic Signal Analyzer is a precision, full-featured signal analyzer that offers state-of-the-art performance at a price that's less than half that of competitive analyzers. Buildin
Electronics Forum | Fri May 01 14:46:52 EDT 2015 | aprosser
Good afternoon, We are running some aluminum boards through a 7 zone reflow oven which have 2 4 pin right angled headers on the ends that are skewing. Does anyone have any suggestions to prevent this from happening?
Electronics Forum | Fri May 01 21:10:22 EDT 2015 | sarason
They are probably getting a little hot. So that leaves several courses of action. 1: Don't place them before reflow and hand finish. 2: Shield them with a little folded shield to decrease heat transfer. 3: Speed up the time through the oven, but th
