Model name :HP-520SPI Benefit High speed printing realization (2.0Cpk @ ±25㎛) Fine Pitch(0.2mm) , CSP , 0402 Control of printing speed and pressure over 5 sections Various PCB Clamping options depend on PCB t
MODEL NAME: HP-350MD ; HP-620MD Benefit High speed printing realization (2.0Cpk @ ±25㎛) Fine Pitch(0.2mm) , CSP , 0402 Control of printing speed and pressure over 5 sections Various PCB Clamping options depend
Electronics Forum | Thu May 18 09:18:33 EDT 2006 | Chunks
Hi dwelch123, 8 mils seems a bit thick to me. I would normally go 6 or 5 mil for fine pitch such as this. One other area to check is the the snap off. Are you using the slow snap off or just lowering the board right after print? If so you should
Electronics Forum | Wed Sep 01 12:58:42 EDT 2010 | scottp
A good paste will print fine up to 5 in/sec or so. They key, as mentioned, is to get the pressure right for a given squeegee speed. If the squeegees aren't giving a clean wipe then you'll see huge variation in print volume which can lead to shortin
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/RSS_how-to-turn-off-autoupdate-exe_topic1936.xml
PCB Libraries Forum : How to Turn Off AutoUpdate.exe PCB Libraries Forum : How to Turn Off AutoUpdate.exe This is an XML content feed of
GPD Global | https://www.gpd-global.com/co_website/pdf/doc/FLOware-Software-Guide-Addendum-Deferred-Reverse.pdf
. Used to avoid running the needle into tall board elements. Can be used in conjunction with Snap Off Z to maintain a high needle height during movement to the next dispense location