Electronics Forum | Mon Jan 08 19:52:14 EST 2007 | fastek
A soft limit error is an error due to trying to drive the head outside it's mechanical limits. Check your X-axis program data for this part.
Electronics Forum | Tue Feb 09 12:15:14 EST 2010 | rajtaware
Check if the feeder position is out of picking area mentioned in manual. Change the feeder position.
Electronics Forum | Tue Feb 09 13:27:05 EST 2010 | duchoang
Re-optimize the program. One (or more) head(s) can not reach and pick up parts from certain feeders.
Electronics Forum | Mon Jan 08 01:47:35 EST 2007 | fpcb
hi to all, I have a old MPA-80 machine. I use it for simple boards without problems till now. For a more difficult board I have tried to use command "M801", I think that I have done everything right but I receive a error-message like " x(-)soft
Electronics Forum | Tue Feb 16 09:37:05 EST 2010 | davemacnemo
Stumbled around in the data management section for a while and found that the board origin somehow got its sign changed from -ve X value to +ve :o/ - Is there any way to change the colors on the display. Someone has made some really bad choices (blac
Electronics Forum | Wed Oct 31 03:35:41 EDT 2007 | meritajs
Hello All, We have problem with one from our YAMAHA SMT mounter. It had weard defect. It gives error message"soft limit X over" when next step must pick up with head3. But all coordinat for next component do not exeed movable range. This failure happ
Electronics Forum | Thu Jul 25 00:42:02 EDT 2013 | felo188
Hello everyone! I have problem with using vision in csm v60. Below describe: 1. Machine's third head takes one IC from tray 2. Goes to vision and take picture and moves IC 3. Goes to pick and place 4. When nozzle wants to place IC on board the
Electronics Forum | Thu Nov 01 17:24:20 EDT 2007 | jmelson
I think the Yamaha 84S is very similar to my Philips CSM84. head 3 cannot reach all the feeder locations. I believe feeder locations 1-3 on the front rail, and is it 41-43 on the back rail (the first 3 again) are out of range for the X axis to move
Electronics Forum | Tue Sep 26 10:22:51 EDT 2006 | SWAG
Histogram: Place standard tooling block in centernest. Jog camera over block. Jog z-axis to soft limit. Place a white card under camera. User mode to test. Turn board lamp on. From test menu, select histogram. With board lamp on and white under camer
Electronics Forum | Mon Mar 30 15:16:32 EDT 2009 | Peter
Hi Tom, You're right. I do find the second locating pin hardware. Now I got them both up/down when F3 is pressed. Thanks. I don't see any pin on the hardware and no edge clamp hardware either :-( , do you know any way that I can bypass these hardware
