Electronics Forum | Fri Jun 16 11:28:53 EDT 2000 | Boca
Solder 'follows' heat. 1. Preheating is a great idea, use a baking oven to get the whole assembly up to temperature, use the preheaters in your wave solder machine (without wave) to preheat the assemblies ... 2. Or use the biggest soldering iron
Electronics Forum | Tue May 09 22:57:58 EDT 2006 | davef
The NexLev connector is built in a stripline construction, providing a continuous ground plane for each signal contact. The connectors come as tenrow connectors with 100, 200, or 300 positions at possible stacking heights from 10 mm to 30 mm. Technic
Electronics Forum | Wed Nov 21 19:45:36 EST 2001 | Yngwie
Hi Guys, I need help. I�ve a trouble with non-wetting problem on the lead of 208 pin, 20 mils pitch QFP. We are on intrusive reflow. I never faced this problem before on this product after running them for about 2 years now. This occurred on one pa
Electronics Forum | Thu Feb 10 09:08:21 EST 2000 | C.K.
We've got this hard-to-Wave-solder board where all of the SMD's are on a ground plane - in fact the entire bottom-side is a ground plane. Our designers have incorporated thermal relief on some of the pads, but for reasons unknown to us, they don't h
Electronics Forum | Thu Feb 10 22:31:11 EST 2000 | Dave F
CK: If you�ve done everything under the sun process-wise at the wave: different fluxes, more heat, less heat, more contact time, and less contact time; and are running out of ideas; let me table some thoughts. � "Don�t mess with Mother Nature."
Electronics Forum | Wed Feb 16 07:55:19 EST 2000 | Dave F
CK: I hear you about pads. Most secondary side SMT pads are primary side SMT pads that are on the secondary side. This only matters when boards are wave soldered. Rather than changing to larger components, consider a bigger fight than that ... ge
Electronics Forum | Fri Feb 11 10:14:54 EST 2000 | C.K.
Dave, to answer your questions, point-by-point: � Just out of curiosity, how are second side, skippy components oriented on the board with respect to the wave? The SMD's are all oriented in the "correct" direction with respect to wave direction(i
Electronics Forum | Wed Sep 07 00:47:53 EDT 2011 | woodsmt
PCB, What is telling you that you have cold solder? You do not give much info. My QA/QC love this term to describe a multiple of issues. They are usally very wrong. If this is a reflow process and it just affects one part? An SSOP is not likley t
Electronics Forum | Thu Jan 17 11:49:54 EST 2008 | wayne123
HI, I have ran into this a time or two, and what I did before we got the BGA rework station was to run some flux under the component, and since the flux that was in the solder on the other solder joints has at least part of the way burned off in the
Electronics Forum | Fri May 01 22:05:23 EDT 1998 | D.Lange
| I've never seen this before. Today, I got this tombstoning on Tantalum Capacitors (Okay, I saw that before) | Here's the part that seems weird to me: | -They didn't tombstone onto a termination - they went onto their sides! That's right, both ter
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
