Electronics Forum | Mon Jul 16 09:04:00 EDT 2001 | Hussman
No argument here. But I've don't think I've ever seen solder balls on 0402s. Even when they're placed on narrow G dimension pads, where there is little toe fillet, I've never seen a solder ball. But your idea of reversed homeplates would work grea
Electronics Forum | Fri Jun 12 11:15:50 EDT 1998 | Ryan Jennens
Hey all! The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a pallet w
Electronics Forum | Tue Jul 17 15:13:53 EDT 2001 | mparker
Dave - I agree that the U shape for QFP's sounds a bit whacked, for the reasons you state. It may work OK for larger pitchs but then again there are a myriad of fixes that work before resorting to U shapes. With the U shape removing paste from under
Electronics Forum | Wed Jan 15 21:55:41 EST 2014 | padawanlinuxero
we do that and there's a variation on the solder temp. sometimes around 10 degrees, we have 2 solder pallets that are run in intervals of roughly 3 1/2 minutes a part (the time that take the operator to put all 3 terminals in a 42 pcbs per board, and
Electronics Forum | Tue Jan 21 13:51:19 EST 2014 | rgduval
Armando, Is the problem in the same spot on the board with every run? If so, there might be something about that particular location that is part of the cause (ie. ground or power plane connection). It sounds like you're seeing blow holes, or insu
Electronics Forum | Sat Sep 21 23:38:06 EDT 2002 | ivanchu
I got one problem from my production line recently. One 0.5mm pitch QFP IC have been used on my PCBA. Actually, the defect was happened in randomly. Sometime, we got the fillet completely but sometime is not. The solder joint look like is good, but t
Electronics Forum | Tue Dec 17 11:01:24 EST 2002 | Tim Marc
Hello all, One of our PCB manufacturers coated a through hole connecters vias with solder mask. The only IPC references that comes close to describing this problem is 2.9.2 Registration to holes, and subsequent specification 6.3.1 PTH � Vertical fil
Electronics Forum | Tue Feb 19 19:36:21 EST 2002 | davef
You weren�t clear but I assume the problem is not widely distributed and affects only a few parts on each board. Do this trick: * Cut a ~1� piece of fairly serious wire, like 18 or 12 AWG. * Strip the insulation. * Gear-up with gloves, glasses, and