Electronics Forum | Mon Feb 12 10:02:18 EST 2007 | rgduval
A little late to the party here, sorry... Has the joint been verified as a cold solder joint? That is, visually confirmed that it looks like cold solder, and, perhaps, xrayed to confirm the solder status? X-raying may sound a bit extreme, but you'
Electronics Forum | Thu Nov 29 22:31:27 EST 2007 | shy
Hi Stephen, The component falling off is the component that had glue. the component witout glue is being covered by masking during wave. What is the meaning by populated the part and cure it? is it run with solder paste profile or glue profile or yo
Electronics Forum | Mon Sep 21 20:45:55 EDT 2009 | davef
10.4. Pre-Cure Examination. Immediately after material application, the uncured conformal coating shall be examined for: a. Bubbles and Air Entrapments. These defects shall be broken by vacuum, with a sharp probe, or other appropriate tools. b. Bridg
Electronics Forum | Mon Aug 24 21:16:57 EDT 2020 | smith88
I am trying to teach a class and the question came up about loss of metalization of the Earth pad on a chip filter. This pad is on the side of the component. I can not find a IPC call out for this type of side termination other than 3 or 5 sided 9.1.
Electronics Forum | Thu Aug 09 16:24:27 EDT 2018 | ks0707
Hi Thomas, Thank you for your posting and I agree with you that Printing is the most difficult one. BTW, after you ran the one side (let's say Bottom side), my engineer worries about the distortion of flex board because of the thickness. In that ca
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
.png)
