Electronics Forum | Fri Oct 29 09:36:42 EDT 1999 | Dave F
Chris: Thanks. SMTnet has a "Library." Buried deep within it is a listing of terms. The following is from that listing: Shadowing. When a component blocks the heat or solder wave flow from certain areas of the printed circuit board, resulting in
Electronics Forum | Thu Nov 04 21:36:36 EST 1999 | chris
Hi John, Thanks to your reply, just one question is it possible that the solder paste ( flux material )applied to the pads cause the non-wet. regards Chris
Electronics Forum | Thu Aug 21 12:31:54 EDT 2003 | adlsmt
I have some finished boards that I have concluded have "black pad" defect. Outside of the black crap on some of the solder joints, if the boards are electrically functional, are they reliable? Any opinions would be appreciated as I dont want to throw
Electronics Forum | Fri Nov 05 10:01:04 EST 1999 | Dave F
Chris: You can have more than "one question!!!" Anyhow, yes crappy solder paste can cause non-wetting, but before you go there understand why the paste is wetting some surfaces, but not others. Ta Dave F
Electronics Forum | Thu Aug 21 22:10:07 EDT 2003 | adlsmt
Well, for some reason the board house will pay for the boards but has some issue with paying for the parts on them. Why am I not supprised? Perhaps I have mis-diagnosed the problem. We have found two different board p/n's with the same type of defec
Electronics Forum | Tue Jul 18 03:04:46 EDT 2006 | sharifudin
We are trying to reduce the number of unit fail at QA Visual Inspection due to Solder On Gold Finger. We know so far that the solder is spattering onto the Gold Finger during reflow. I need some advise on what kind of process can improve to reduce th
Electronics Forum | Thu Jul 20 03:00:53 EDT 2006 | reypal
If you are using SMT machine for component placement you may check your nozzle where in some cases solder paste stuck to it and during placement will easily get into gold pad area. otherwise you have use kapton tape in order not to expose those pads.
Electronics Forum | Thu Jul 20 05:04:30 EDT 2006 | bing007
We had a similar problem with gold contact pads. Cleanliness is paramount. If you are using foil tensioning system, wash the foil in a stencil wash before use as the cardboard cassettes may be contaminated. Be very careful when loading into a frame f
Electronics Forum | Fri Jul 16 22:44:27 EDT 1999 | Vic Lau
| We are currently assemblying several different board type with gold plated lands with varying results. Can any of you that has successful experience in this area give me some pointers. What paste do you use? Do you use the recommended reflow pro
Electronics Forum | Fri Oct 05 18:59:53 EDT 2001 | Dan Steffler
I have had an issue where solder has contaminated gold plated pads (fingers) where it is not acceptable. The pads must remain perfectly coplaniar for a LCD zebra strip to lay accross them. Does anyone know of a way to remove the marriage level of s
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
