Electronics Forum | Mon Aug 27 15:02:45 EDT 2001 | davef
It�s uncommon to test green strength. [Whatever �green strength� is. Some chip bonder adhesive suppliers have taken to taking about improvements in �green strength� their literature. We have asked sales types to quantify this and have never heard
Electronics Forum | Thu Feb 17 11:38:53 EST 2000 | Steve Thomas
We appear to have solved a major reflow process problem (poor quality joints on a 20 mil QFP100...excessive solder left on the lead leg, not much left for a joint) with a design change to the board. We gave ourselves considerably more room for a hee
Electronics Forum | Thu Feb 17 11:38:53 EST 2000 | Steve Thomas
We appear to have solved a major reflow process problem (poor quality joints on a 20 mil QFP100...excessive solder left on the lead leg, not much left for a joint) with a design change to the board. We gave ourselves considerably more room for a hee
Electronics Forum | Mon May 14 16:52:19 EDT 2001 | John
We have been running a product for the past several months using Loctite 3615 in our adhesive dispenser (Camalot 3800). The program the machine has been running has gone unchanged for quite some time now and everything has run well. Today, it appea
Electronics Forum | Fri Apr 20 16:05:17 EDT 2001 | gcs
We always reduce side to side, EXAMPLE: 12 mil width reduced to .010". Do you guys check viscosity ? Also maybe your guys are appling to much pressure on the sqweegee blades.
Electronics Forum | Tue Apr 19 09:09:28 EDT 2005 | russ
Here is one reason- It eliminates the viscosity change during printing operation from the paste warming up and getting thinner. I would contact your paste supplier and have them give you the full list.
Electronics Forum | Fri Jan 21 11:00:56 EST 2011 | xps
Hi, in my experience, the humidity is trapped in the solder paste. Otherwise you can also try to : adjust preheat profile, and /or increase paste viscosity, and /or increase paste metal content (they are the most common causes).
Electronics Forum | Thu Oct 27 06:05:50 EDT 2022 | angela t
SMT chip processing short-circuit bad phenomenon mostly in the fine pitch IC pins, mostly in the 0.5mm and the following pitch between the IC pins, because its spacing is small, improperly designed template or printing a slight omission is very easy
Electronics Forum | Sat Jun 25 00:52:31 EDT 2005 | ktron
Hi all, Recently I had problem with printing the lead free solder paste, almost every board has bridging especially on the fine pitch locations. Anyway this problem never happens when we use leaded solder paste. So I would like to ask if there are a
Electronics Forum | Mon Sep 17 17:09:32 EDT 2001 | jschake
Flux: No-clean pastes tend to have a wider print process window in terms of print speed and pressure. More importantly, no-clean pastes are more tolerant to changes in temperature and humidity. They also exhibit longer stencil life than water-solub
