Electronics Forum | Tue Mar 23 23:17:03 EST 1999 | Chris G.
| Are there many of you who are soldering through hole parts in your surface mount reflow oven? How repeatable is the process? Do you need to touch up a lot after reflow? We don't do long runs maybe 200, 300 boards max. Can you just screen print
Electronics Forum | Tue Jan 30 01:32:24 EST 2001 | PeteC
Bill, We do solderpaste reflow on through-hole here every day on plated-thru-holes. We do it on connectors only. It is a reliable process. We use no special profile. The stencil apertures must be modified for this process. Check out the IPC-7525 "St
Electronics Forum | Wed Apr 13 21:17:18 EDT 2022 | stephendo
If it was ROHS, I would say that the pads are definitely dissolved away. And it sounds like that is the case here. Your best bet is if it is class 2 and the barrels are at least 50% then push for them to be accepted. If you are trying for more barr
Electronics Forum | Fri Apr 15 09:56:17 EDT 2022 | winston_one
Thank's Dennis. I'm also now think in this direction. Process was adjusted and soldering are good. But one from five boards can have this effect with bubbles and strange uneven distribution of solder inside the barrel. Probably copper is too thin and
Electronics Forum | Fri Apr 04 09:54:39 EDT 2008 | redtiger56
We have been seeing continued difficulty with solder shorts and/or insufficient barrel fill with our Juki selective solder machine while using SAC305. We want to switch to something in the SN100 series, but we do not know enough to seperate the hype
Electronics Forum | Mon Dec 02 18:01:12 EST 2002 | GSW
Hi, Try to check if there is water absorbed in the flux or the humidity around the wave area. possibly plating on barrels that might be damaged?
Electronics Forum | Thu Apr 14 15:27:05 EDT 2022 | ppcbs
If it was ROHS I would suspect copper migration. In my experience an acceptable copper finish should last up to at least 6 reflow cycles. If you have bubbles or blow holes in the solder joint, that is a sign of voids in the walls of the copper barre
Electronics Forum | Wed Apr 13 12:10:47 EDT 2022 | winston_one
Hello! We have a strange effect. Some pads of big trough-hole DDR slot just dessapear. Initialy it was soldered with selective soldering process (leaded, 290 degrees, ImSn finish, very short storage). Then some connectors with poor barrel fill we hav
Electronics Forum | Thu Apr 14 13:49:34 EDT 2022 | winston_one
Thank you for reply, Stephen. No, As I wrote it was leaded process. I heard that it is possible with lead free solder at higher temps an dwell time. At NPL Defect Database I've find this case wich looks exactly the same: http://defectsdatabase.npl.co
Electronics Forum | Fri Mar 31 12:27:27 EST 2006 | Marcus
We have used the SN100C for over a year now with fanastic results. We use the SAC305 for SMT and SN100C wire exclusively. There are no problem mixing the alloys. I am also on the commitee for the NASA testing. The SN100C did out perform SAC and SnPb