Electronics Forum | Wed Aug 18 00:41:15 EDT 2004 | Grant
Hi, We have the Soltec Delta C. It works well, and is very stable. I think the software is a bit simplistic, but it keeps the wave stable, so that's the main thing. It's the timer on the software that I find annoying. It has a warm up time, and yo
Electronics Forum | Mon Jun 12 13:49:47 EDT 2006 | grantp
Hi, Thanks guys for all the suggestions. I am going to check what options we have for top side heating. Do people recommend we get convection for that? Also, we seem limited to 60% in the machine setup, and does anyone know how to run the top lam
Electronics Forum | Thu Oct 22 01:43:43 EDT 1998 | Frank J. de Klein
| My company is looking for higher density for card layout. One suggestion has been locating active components packaged in SOT's and SOIC's on the B-side of the card. This in turn will require wave soldering of the above mentioned components. When I
Electronics Forum | Wed Dec 14 13:11:27 EST 2005 | grantp
Hi, Thanks for the ideas, and I liked URL's idea of seeing if we can move the in feed sensor, that might hold the board wile the other is feeding in. Our in feed conveyer is also much faster than the oven, and I wonder if we can change that. I will
Electronics Forum | Tue Jun 13 09:14:37 EDT 2006 | samir
As I mentioned in another thread, I've always been one to flux the living crap out of a board until the ICT guys start yelling at me, which actually did happen last week. I had a little oriental guy (an immigrant to Riyadh from Vietnam), clicking an
Electronics Forum | Fri Jun 09 22:22:59 EDT 2006 | grantp
Hi, Very funny, and I feel so much better not because of your advice, but because your a Dr Dr PhD, and we all know thats more important than experience! Seriously though, so you think we should be ok with the zones we have? We are not sure, and so
Electronics Forum | Sat Jun 10 11:16:10 EDT 2006 | Dr. Bocephus H good time budwieser Expert Guru Phd. DDs. Wow!
Yeehaa! there little doggies, y'all just got to mine that there smuckonium or that there, other stuff that fella dr. guru recomends. Doin' that and all yer problems magically dispear. Grant, sounds like you're in a tree like a one balled coon chas
Electronics Forum | Sat Jun 10 00:43:34 EDT 2006 | mika
Dont't bother to answer real idiots! I can relate to a similar problem. We also use SN100C alloy and the solder pot get(got?) contaminated with the alloys from the SAC305! How can this be? Strange thing happens during the soldering process, and it o
Electronics Forum | Tue Jun 13 06:20:45 EDT 2006 | bk
Well grant just to let you know i feel your pain. I've been wavesoldering with sn100c since January and let's say i'm still learning everyday. Some of the typical causes of bridges are not enough flux when the board hits the solder. Also it can be bo