Electronics Forum | Fri Jun 09 21:53:07 EDT 2006 | Professor Besserwisser Dr Dr PhD
I am sorry, but I hope No hard feelings? :) As for an answer to Your question: No I can not see the reason for using three heat zones on the wave. Anybody else?
Electronics Forum | Tue May 22 00:29:02 EDT 2007 | grantp
Hi, Thanks for the info, and would you opinion be that the Soltec selective is a good machine, and is the software good? We have a Delta Wave, and while we like it, it's got some horrible software. That's the only thing worrying us. Regards, Gran
Electronics Forum | Wed Jul 29 12:52:15 EDT 2015 | e405453
Hi Thank you for the reply. I will going on contacting my supplier. we are currently using 2 different wave machines a Soltec Delta wave & Opti Flux on SpeedLine Machine. Th
Electronics Forum | Thu Jan 05 15:34:55 EST 2006 | Joe Wesley
Electrovert does not seem to be cheaper. Still about 30K more than the Delta. We are investigating too, we are concerned about the dross build up and flow design in the electrovert. The Soltec Machine seems to have less of an issue and maintenance ap
Electronics Forum | Wed Mar 16 17:34:20 EST 2005 | pmd
decrease pump rpm, for penitration try tweeking pitch as well as belt speed. On the delta wave spray pitch and belt speed are related.
Electronics Forum | Mon Jun 12 10:34:06 EDT 2006 | cuculi54986@yahoo.com
My brother-in-law is a DDS and I trust him. We had some problems with solder voids in the past, and he was invaluable. He'd drill them out and fill them with SAC3240X+.
Electronics Forum | Mon Jun 12 10:46:38 EDT 2006 | Chunks
It's hard to believe MoonMan spends this much time typing these rants. Guess the boys at ever so much higher I.Q. standard of engineering, IPC, kicked him out there too.
Electronics Forum | Tue Jun 13 08:49:34 EDT 2006 | russ
Your new problem is inadequate flux coverage. This may be a contributer as well to the BNC issue. Russ
Electronics Forum | Mon Apr 09 11:31:36 EDT 2018 | emeto
I would still focus on the sensors first. Experiment and see if they are really registering correctly. Still might be a sensor malfunction, timing issue(enough time to register)or some actual debree on it that prevents it from changing state properly
Electronics Forum | Mon Apr 09 13:50:38 EDT 2018 | justconmac
Thank you, yes I am definitely going to go back through and clean them thoroughly and monitor them, especially at rack location.