Electronics Forum | Fri Apr 21 00:56:44 EDT 2006 | pavel_murtishev
Good morning, MPM AP25 we have is equipped with dedicated vacuum support only, no side snuggers. Also we had a lot of issues with fine pitch paste deposition due to this poor support. Vacuum support can�t fix wrapped boards properly causing a lot of
Electronics Forum | Tue Apr 08 08:57:04 EDT 2008 | toddl
We had a similar issue with a UP2000. We had motherboard problems and needed a new one. Our original board had a 33Mhz CPU but none were available, Speedline told us we needed to buy the upgrade. One of their techs told me that they had a 66Mhz mothe
Electronics Forum | Mon Jun 25 19:36:36 EDT 2007 | bga_kid
If you calculate CFM using the numbers you have provided you are pulling 1396CFM out of the oven. I am not sure what Hellers spec is but I know a Speedline OmniExcel Air machine should be set at 300CFM. I do know for a fact that to much exhaust can s
Electronics Forum | Sat May 17 09:12:50 EDT 2008 | davef
Lead-free means expensive tin. Tin is an excellent solvent. So, metal parts in contact with molten tin must be expensive enough to resist that nature of tin. To learn more about this: * Search the fine SMTnet Archives * Look here: "Liquid Tin Corrosi
Electronics Forum | Wed Aug 03 10:56:47 EDT 2011 | cyber_wolf
We have a new MPM Momentum. It's hands down the best printer we have ever worked with. Load program--add paste---forget about it. Runs every day all day with no issues what so ever. I come from a "machine background" and the MPM's are much more robus
Electronics Forum | Mon Oct 19 21:34:00 EDT 1998 | Peter
Jim, We purchased the SMTech 500 printer that was shown at Nepcon this past spring. We are very happy with the machine's performance and their service was excellent when it was SMTech. There are still minor software bugs that we are encountering bu
Electronics Forum | Tue Oct 17 18:15:39 EDT 2006 | daxman
Hey all, I just though I give you all a quick update. I managed to get the printer working. The problems were a combination of everything that was discussed here. When I adjusted the GS4 pot for the histogram, I turned the wrong one at first. This t
