Electronics Forum | Sat Jul 16 18:24:11 EDT 2016 | aemery
Scratches do not necessarily mean bad! Usually the forcer motor fails before a platen. The motors become weak or don't evenly distribute the supplied air, which causes them to tilt and drive into the platens. Mechanical misalignment of the VY forcer
Electronics Forum | Tue Mar 18 11:52:38 EDT 2008 | rrpowers
A couple years back we were looking at going to an enclosed solder paste printing process, similar to the ProFlow, Crossflow, or Rheometric Pump. We have older MPM AP25's with a custom transport. Speedline told us that in order to add the RheoPump,
Electronics Forum | Tue Jan 13 19:16:03 EST 2004 | pjc
Dedicated tooling uses what MPM calls an "H" tower. You mount the board support plate (dedicated tooling) on top of the H tower. If boards are only single-sided SMT, meaning only components on one side, the board support plate is flat with vacuum hol