Electronics Forum | Mon Apr 04 17:13:36 EDT 2022 | rdssmt
Michal good morning. Can you helping with the software and send me the cost please. Regards.
Electronics Forum | Mon Apr 04 20:09:18 EDT 2022 | compit
Tomorrow I will try to rip from the computer. Today I have 22 PM.
Electronics Forum | Mon Apr 04 21:38:26 EDT 2022 | rdssmt
Email. Ricardo.duran@duro-manufacturing.com rdssmt@yahoo.com.mx Thanks.
Electronics Forum | Wed Dec 28 11:05:27 EST 2022 | atpico
We have 7.2E (MS-DOS variant) software version on our printer and there are some annoying bugs and less than optimal NPI process (when the new board need to be put on and put off the rails several times during NPI teaching). Is there a known newer/be
Electronics Forum | Sat Jan 21 11:39:11 EST 2023 | atpico
Thank you Michal, The MPM error messages are ambiguous to say the least and one axis not zeroing was a possible cause. But I put here what I learned again and again with this machine: when something doesn't work start by checking the fuses, all of
Electronics Forum | Fri May 04 14:47:15 EDT 2007 | jasont
Chris, I have x2 units available in my Brockville, Canada warehouse now. They are off MPM UP 2000 HiE's and the model #'s are as follows; MCU012A-SOO AP25-917A Please e-mail directly at jason@tekmart.com Looking forward to your reply, Jason
Electronics Forum | Sat Jan 21 10:28:16 EST 2023 | compit
The so-called "drivers" are used to control each servo - control boards at the back of the machine. There are several (8?). If one is "worn out" and has no strength to move the servo, maybe this is where the error comes from? They can be interchanged
Electronics Forum | Wed Jul 19 07:27:09 EDT 2023 | roachindignant
This problem appears whenever I turn on my UP2000 HiE printer and try to perform the initial Reset. Hardware Limit Warning (E00938:10) All sensors on the Input/Output Screen are functioning appropriately and will give expected results when checked
Electronics Forum | Wed Nov 01 00:19:29 EST 2006 | Cingular Man
Are you setting up double side PCB that has the tall components on the bottom that being push up by the support pins... ??? Or because your vacuum is leak and not holding the board at the same spot every time you are loading the board.... Board warp
Electronics Forum | Mon Aug 26 11:13:49 EDT 2002 | Marco Prince
There is a new tooling invention called the Instant Fixture System. It is a mechanical "cartridge" style dense pin-array system. There is a kit for MPM-UP 2000, and AP Series, and also for DEK-265 platforms. This instant fixture system offers very