Electronics Forum | Mon Dec 27 05:23:03 EST 2021 | jineshjpr
Hi Djo, very much sorry to say that no gbx file is available with me (Customer not yet supplied). Sharing you image of stencil design.
Electronics Forum | Thu Nov 07 10:59:11 EST 2002 | pjc
IPC-7525 "Stencil Design Guidelines" is a good reference document to have. Here are notes from a Tessera, (a major mBGA mfg.), study- "Application Note Solder Stencil Requirement for mBGA" The stencil aperture is to be square, equal in size to the l
Electronics Forum | Fri Jan 23 18:03:06 EST 1998 | Steve Gregory
Paul, I've got a third-level ISO Stencil Specification procedure that I did at a past employer that I'll send you...it also deals with the DEK-265 printer (which is what we used) when I talk about frame sizes and image positioning, but you can edit i
Electronics Forum | Fri May 13 13:06:09 EDT 2005 | bschreiber
The Smart Sonic StencilScan AOI software can easily create Gerber data from PCBs, film, stencils, screens, mylar images, etc. Bill Schreiber Smart Sonic Corporation Tel: 1(818) 610-7900 E-mail: bill@smartsonic.com Web: http://www.smartsonic.com
Electronics Forum | Mon May 05 08:42:35 EDT 2008 | mmjm_1099
We use double image stencils with our DEK Horizons. My operators would just load the pcb on to the rials and manually adjust the stencil and clamp it. Once they do that they add into the comments what number the handcrank adjustable is at so next tim
Electronics Forum | Wed Sep 23 15:16:22 EDT 2009 | davef
Santiago can still maintain his current PTH, SMT, Reflow, Glue, Wave solder process flow and print glue with a stencil. In this, the bottom-side [contact-side] of the glue stencil requires cutting pockets that correspond with the clinched PTH leads.
Electronics Forum | Fri Feb 02 12:48:29 EST 2024 | spoiltforchoice
Do it all the time. With an automatic printer you would have your two images at opposite edges of the stencil and to switch between them you would remove the stencil and rotate it so the one you want is at the front. Naturally you need to make sure t
Electronics Forum | Thu Aug 13 14:52:42 EDT 2015 | deanott
We just encountered a problem with the vision on our MPM Accuflex. We just switched jobs and when we went through a 'Vision Set-up' there was no image (just blank gray screen where you'd normally see the PCB or bottom of stencil). When we tried to
Electronics Forum | Mon Jun 24 10:19:23 EDT 2019 | slthomas
I have not added images in quite some time but the "Attachments" feature below the window where you type your post will steer you through it. You just have to have the image hosted someplace that you can point to. Just for
Electronics Forum | Tue Jun 23 11:27:37 EDT 1998 | Russ M
Has anyone seen/used these yet? They seem to have lower coefficient of friction for release of paste and less wear and tear as well as conforming to the board better (plastic has better memory than stainless). Also there is no mesh so a larger image