Electronics Forum | Thu Aug 22 22:19:13 EDT 2019 | sssamw
From the picture you present, it is a pin in paste part with pin length 2.2mm (a good length for 1.6mm PCB thickness), and seems the pin tilted and touch on PCB surface, thus causes up-part. Sorry I cannot image pin tilted not before placement but i
Electronics Forum | Sat Feb 12 20:02:04 EST 2005 | Mike Konrad
As for specific recommendations, I�ll defer to �real users�. But here are the usual suspects: Aqueous Technologies http://www.aqueoustech.com (909) 944-7771 Ultrasonic Smart Sonic http://www.smartsonic.com (818) 610-7900 Ultrasonic PMR http://www
Electronics Forum | Thu Mar 25 09:38:36 EDT 2021 | spoiltforchoice
Well everything Graham said with some additional points.. You mention manual printing but very little about your stencil or setup. Everything you have said indicates a very limited budget has been expended, however what you have is an extreme exampl
Electronics Forum | Wed Jun 09 15:03:53 EDT 1999 | Earl Moon
| In past PCB designs I have cleared all traces from all layers | (except pwr/gnd) from fiducial area. It has come to my attention that this is only necessary on the side where fud is placed. Which is the correct method of design using a fidicial?
Electronics Forum | Sat Aug 14 07:01:44 EDT 1999 | Earl Moon
| Has anybody adopted the method of stencil printing with the board at a 45 degree angle to the squeegee blade? What are the benefits and drawbacks? I've heard you get better fine pitch results. | | TX | Mark | I know we all seek easy/better solut
Electronics Forum | Sun Mar 04 02:39:27 EST 2012 | eadthem
I don't have our DEK printer part numbers memorized, In general we have a older machine running NT4.0 . It has 2Di inspection but we never use it because you can only inspect/setup 1 camera shot at once, making for very long programming. Our newer D
Electronics Forum | Fri Jul 30 17:13:30 EDT 1999 | Dave F
| | | Looking for solder paste specification limits which have reliability data to support them. Currently, we are looking to define the min/max volume necessary to ensure a good joint on CBGA, PBGA, and Micro-BGA's. Any information will be greatly
Electronics Forum | Thu Mar 05 13:17:19 EST 1998 | Justin Medernach
| Hello everyone! | Does any know anything about bare board size variations? | Is there a spec. or tolerance? | I'm running small lots of boards and during the screen printing process | I find that I cannot paste each board perfectly.I've tried other
Electronics Forum | Mon Mar 07 09:23:25 EST 2016 | rgduval
We've had our My500 for about four months now, and couldn't be happier. We are a super-high-mix, super-low-volume shop, and the flexibility provided by the 500 over stencils is stunning. So, you buy 5-10 stencils a week? That's 260-520 stencils a
Electronics Forum | Wed Apr 28 11:16:45 EDT 1999 | Steve Gregory
Hello all, I read about Steve's headache a few articles back and I'm really interested by his tip. However, I'm still wondering why square apertures release solder paste better than round ones. For the same volume of paste, the surface area of th